Ok. Changing the end on the tower is not trivial, but it can be done.
Get a little butane torch for the soldering.
------ Original Message ------
From: "Steve Jones" <[email protected]>
To: [email protected]
Sent: 7/10/2017 11:18:20 PM
Subject: Re: [AFMUG] Lmr400 vs heliax when lmr is there
I did most of the crimp on ends..... they are solder ends as it turns
out.. ends would have to be replaced anyway
On Jul 10, 2017 9:55 PM, "Adam Moffett" <[email protected]> wrote:
LMR 400 is perfectly good for the IF cable on a split system licensed
backhaul. I would re-use it without reservation. I might just tweak
the connector to make sure someone didn't half ass it and it doesn't
fall apart in my hand.
------ Original Message ------
From: "Steve Jones" <[email protected]>
To: [email protected]
Sent: 7/10/2017 10:27:45 PM
Subject: [AFMUG] Lmr400 vs heliax when lmr is there
We used to be an all alvarion shop, so all our joints have good
lmr400 runs top to bottom. Part of contractor cleanup is to pull the
lmr. We run bbdge everywhere now, but as we get more into licenced
gear odu may not be the best choice to idu.
Im pulling it solely for pretty, if we went idu new we would go with
a heliax solution. But, as ive shown, im cheap.
Would you pull it or hold on to it? Note my warehouse is full of zero
dollar value stuff i "might need someday" already, and my sites are
like crack dens.
