Try to always put an antenna or load cell on a radio port.
----- Mike Hammett Intelligent Computing Solutions Midwest Internet Exchange The Brothers WISP ----- Original Message ----- From: "Jeremy" <[email protected]> To: [email protected] Sent: Thursday, July 13, 2017 11:43:53 AM Subject: Re: [AFMUG] AirFiber 5 connectorized I usually link them up on the bench, but I don't put any antennas on them. I just face the SMA connectors toward each other a few inches apart. Works with AF11X as well. On Thu, Jul 13, 2017 at 9:02 AM, Chuck McCown < [email protected] > wrote: Yes, 5x From: Kurt Fankhauser Sent: Thursday, July 13, 2017 9:00 AM To: [email protected] Subject: Re: [AFMUG] AirFiber 5 connectorized you talking about an AF5X? Cause the original AF5 I didn't know had a connectorized version, integrated only. On Thu, Jul 13, 2017 at 10:53 AM, Chuck McCown < [email protected] > wrote: <blockquote> Put a paper clip in the N connectors, extend it about 7mm above the end of the connector and give it a 45 degree slant. One slant one way, the other slant the opposite. From: Jaime Solorza Sent: Thursday, July 13, 2017 8:40 AM To: Animal Farm Subject: Re: [AFMUG] AirFiber 5 connectorized Yes I enabled power back off...okay...thanks Jaime Solorza On Jul 13, 2017 8:28 AM, "Colin Stanners" < [email protected] > wrote: <blockquote> No antennas connected? I hope you turned tx power way down, else the food may not have been the only thing frying in that kitchen. Signal strength LEDs activate only when you are quite close to expected signal level so don't rely on them too much. On Thu, Jul 13, 2017 at 9:24 AM, Jaime Solorza < [email protected] > wrote: <blockquote> I configured 2 AF5s last evening for installation later today. I was able access the remote radio and ping across with no issues from kitchen table to counter. I had no antennas or GPS connected. I never saw the LEDs for signal strength light up. These are the first units I have ever configured. Do I need to do anything to activate them? Tak Jaime Solorza </blockquote> </blockquote> </blockquote>
