Yep... Jaime Solorza
On Jul 13, 2017 10:53 AM, "Jeremy" <[email protected]> wrote: > Yeah, I know it isn't great for them. I only do it long enough to see > them link. > > On Thu, Jul 13, 2017 at 10:44 AM, Mike Hammett <[email protected]> wrote: > >> Try to always put an antenna or load cell on a radio port. >> >> >> >> ----- >> Mike Hammett >> Intelligent Computing Solutions <http://www.ics-il.com/> >> <https://www.facebook.com/ICSIL> >> <https://plus.google.com/+IntelligentComputingSolutionsDeKalb> >> <https://www.linkedin.com/company/intelligent-computing-solutions> >> <https://twitter.com/ICSIL> >> Midwest Internet Exchange <http://www.midwest-ix.com/> >> <https://www.facebook.com/mdwestix> >> <https://www.linkedin.com/company/midwest-internet-exchange> >> <https://twitter.com/mdwestix> >> The Brothers WISP <http://www.thebrotherswisp.com/> >> <https://www.facebook.com/thebrotherswisp> >> >> >> <https://www.youtube.com/channel/UCXSdfxQv7SpoRQYNyLwntZg> >> ------------------------------ >> *From: *"Jeremy" <[email protected]> >> *To: *[email protected] >> *Sent: *Thursday, July 13, 2017 11:43:53 AM >> *Subject: *Re: [AFMUG] AirFiber 5 connectorized >> >> I usually link them up on the bench, but I don't put any antennas on >> them. I just face the SMA connectors toward each other a few inches apart. >> Works with AF11X as well. >> >> On Thu, Jul 13, 2017 at 9:02 AM, Chuck McCown <[email protected]> wrote: >> >>> Yes, 5x >>> >>> *From:* Kurt Fankhauser >>> *Sent:* Thursday, July 13, 2017 9:00 AM >>> *To:* [email protected] >>> *Subject:* Re: [AFMUG] AirFiber 5 connectorized >>> >>> you talking about an AF5X? Cause the original AF5 I didn't know had a >>> connectorized version, integrated only. >>> >>> On Thu, Jul 13, 2017 at 10:53 AM, Chuck McCown <[email protected]> wrote: >>> >>>> Put a paper clip in the N connectors, extend it about 7mm above the end >>>> of the connector and give it a 45 degree slant. One slant one way, the >>>> other slant the opposite. >>>> >>>> *From:* Jaime Solorza >>>> *Sent:* Thursday, July 13, 2017 8:40 AM >>>> *To:* Animal Farm >>>> *Subject:* Re: [AFMUG] AirFiber 5 connectorized >>>> >>>> Yes I enabled power back off...okay...thanks >>>> >>>> Jaime Solorza >>>> >>>> On Jul 13, 2017 8:28 AM, "Colin Stanners" <[email protected]> wrote: >>>> >>>>> No antennas connected? I hope you turned tx power way down, else the >>>>> food may not have been the only thing frying in that kitchen. >>>>> >>>>> Signal strength LEDs activate only when you are quite close to >>>>> expected signal level so don't rely on them too much. >>>>> >>>>> On Thu, Jul 13, 2017 at 9:24 AM, Jaime Solorza < >>>>> [email protected]> wrote: >>>>> >>>>>> I configured 2 AF5s last evening for installation later today. I was >>>>>> able access the remote radio and ping across with no issues from kitchen >>>>>> table to counter. I had no antennas or GPS connected. I never saw the >>>>>> LEDs for signal strength light up. These are the first units I have ever >>>>>> configured. Do I need to do anything to activate them? Tak >>>>>> >>>>>> Jaime Solorza >>>>>> >>>>> >>>>> >>>> >>> >> >> >> >
