It's printed on the board towards the left. Both the 10/100 and GigE
versions have four jumpers per port. 10/100 jumpers are pins 4, 5, 7 & 8
individually for the case of split-pair power like the 320 and 430. The
GigE version is pairs (1&2/3&6/4&5/7&8) and will most definitely not do
split-pair power without re-wiring the RJ45 at one end so that two
wrongs make a right.
Yes, I was about 1/2 a second away from screwing up once. Set the
jumpers, put everything back together. Port 1 was set for 4-pair power
and the 48VDC bus. A 450i AP was going there. Everything got upside down
and I almost plugged a regular 450AP into port #1 until I realized my
mistake before it was too late.
On 7/14/2017 4:49 PM, Steve Jones wrote:
packetflux poerinjector plus sync pinout for the jumpers. I have the
document of PoE Injector Diagrams, but it doesn't seem right because
by default these power cambium, but that not the jumper config. Pretty
sure its the wrong document, and with mixing 24 and 48 with three
different radio systems id prefer it be correct
On Fri, Jul 14, 2017 at 4:44 PM, Colin Stanners <[email protected]
<mailto:[email protected]>> wrote:
Here's my version 0.7 from 2012, I need to update it.
On Fri, Jul 14, 2017 at 4:40 PM, Steve Jones
<[email protected] <mailto:[email protected]>> wrote:
Anybody have a current one, I don't think mine us, I'm using
both inputs for 3 different kinds of radios and I am not even
sure on which way to orient the board for the pins. I have 2
320s, a fsk 900, and a ubnt 24v radio
