Ended up being a bad board, was odd to cause the first site monitor was bad too, packetflux gear is never doa, ill get them on the bench and figure out what i broke to cause that
On Jul 14, 2017 7:25 PM, "Forrest Christian (List Account)" < [email protected]> wrote: > That board must be a really early one. I think there was about 100 of > each type which went out without jumper labeling for some reason I forget > now.... > > I sure don't see anything wrong with those jumpers. Are you getting > power lights on the injector? Do you have a base unit to look and verify > that the power is on on all of those ports. > > On Fri, Jul 14, 2017 at 5:02 PM, Steve Jones <[email protected]> > wrote: > >> Pwr 1 48 >> Pwr 2 24 >> 1 320 >> 2 320 >> 3 ubnt >> 4 fsk >> Is this correct? The fsk won't power. But I think I have a syncpipe >> parasitic up there >> >> On Jul 14, 2017 5:21 PM, "George Skorup" <[email protected]> >> wrote: >> >> It's printed on the board towards the left. Both the 10/100 and GigE >> versions have four jumpers per port. 10/100 jumpers are pins 4, 5, 7 & 8 >> individually for the case of split-pair power like the 320 and 430. The >> GigE version is pairs (1&2/3&6/4&5/7&8) and will most definitely not do >> split-pair power without re-wiring the RJ45 at one end so that two wrongs >> make a right. >> >> Yes, I was about 1/2 a second away from screwing up once. Set the >> jumpers, put everything back together. Port 1 was set for 4-pair power and >> the 48VDC bus. A 450i AP was going there. Everything got upside down and I >> almost plugged a regular 450AP into port #1 until I realized my mistake >> before it was too late. >> >> >> On 7/14/2017 4:49 PM, Steve Jones wrote: >> >> packetflux poerinjector plus sync pinout for the jumpers. I have the >> document of PoE Injector Diagrams, but it doesn't seem right because by >> default these power cambium, but that not the jumper config. Pretty sure >> its the wrong document, and with mixing 24 and 48 with three different >> radio systems id prefer it be correct >> >> On Fri, Jul 14, 2017 at 4:44 PM, Colin Stanners <[email protected]> >> wrote: >> >>> Here's my version 0.7 from 2012, I need to update it. >>> >>> >>> On Fri, Jul 14, 2017 at 4:40 PM, Steve Jones <[email protected]> >>> wrote: >>> >>>> Anybody have a current one, I don't think mine us, I'm using both >>>> inputs for 3 different kinds of radios and I am not even sure on which way >>>> to orient the board for the pins. I have 2 320s, a fsk 900, and a ubnt 24v >>>> radio >>>> >>> >>> >> >> >> > > > -- > *Forrest Christian* *CEO**, PacketFlux Technologies, Inc.* > Tel: 406-449-3345 | Address: 3577 Countryside Road, Helena, MT 59602 > [email protected] | http://www.packetflux.com > <http://www.linkedin.com/in/fwchristian> <http://facebook.com/packetflux> > <http://twitter.com/@packetflux> > >
