The gigabit won't work with the 320 without a special cable. The pinning is not gigabit compatible. See below.
In re jumper settings in general, Debbie has a hand-drawn .pdf which she'll send you with the jumpers for the PowerInjector+Sync, assuming it was your ticket in the ticketing system I noted earlier, if not send a email into [email protected]. It's the same drawing that josh linked to, with the pinning reversed left to right. Generally for the 320, set it the same as the traditional cambium pinouts (should come from the factory that way) (4,5-, 7,8+), and then wire as follows: Pins 1,2,3,4,6,8 straight through. Swap pins 5 and 7. I.E. pin 5 on one end of the cable goes to pin 7 on the other end of the cable. Or put differently: on a standard 568B cable, on one end only, swap the blue/white and brown/white wires. Personally, I like to make a little dongle with a single port keystone wall jack on a short piece of CAT5 with the swap above to make it obvious that an 'adapter' is place. On Thu, Jan 25, 2018 at 11:02 AM, Ty Featherling <[email protected]> wrote: > Can anyone tell me the proper jumper settings to power cap320 aps from > the latest SyncInjector Gigabit? I'm replacing an old model that was > designated for Canopy430 and I don't want to blow up my radios or my SI. > > > -Ty > -- *Forrest Christian* *CEO**, PacketFlux Technologies, Inc.* Tel: 406-449-3345 | Address: 3577 Countryside Road, Helena, MT 59602 [email protected] | http://www.packetflux.com <http://www.linkedin.com/in/fwchristian> <http://facebook.com/packetflux> <http://twitter.com/@packetflux>
