Thanks Forrest. I'll make some adapters.
On Jan 25, 2018 1:04 PM, "Forrest Christian (List Account)" < [email protected]> wrote: > The gigabit won't work with the 320 without a special cable. The pinning > is not gigabit compatible. See below. > > In re jumper settings in general, Debbie has a hand-drawn .pdf which > she'll send you with the jumpers for the PowerInjector+Sync, assuming it > was your ticket in the ticketing system I noted earlier, if not send a > email into [email protected]. It's the same drawing that josh > linked to, with the pinning reversed left to right. > > Generally for the 320, set it the same as the traditional cambium pinouts > (should come from the factory that way) (4,5-, 7,8+), and then wire as > follows: > > Pins 1,2,3,4,6,8 straight through. > Swap pins 5 and 7. I.E. pin 5 on one end of the cable goes to pin 7 on > the other end of the cable. > > Or put differently: on a standard 568B cable, on one end only, swap the > blue/white and brown/white wires. > > Personally, I like to make a little dongle with a single port keystone > wall jack on a short piece of CAT5 with the swap above to make it obvious > that an 'adapter' is place. > > > On Thu, Jan 25, 2018 at 11:02 AM, Ty Featherling <[email protected]> > wrote: > >> Can anyone tell me the proper jumper settings to power cap320 aps from >> the latest SyncInjector Gigabit? I'm replacing an old model that was >> designated for Canopy430 and I don't want to blow up my radios or my SI. >> >> >> -Ty >> > > > > -- > *Forrest Christian* *CEO**, PacketFlux Technologies, Inc.* > Tel: 406-449-3345 | Address: 3577 Countryside Road, Helena, MT 59602 > <https://maps.google.com/?q=3577+Countryside+Road,+Helena,+MT+59602&entry=gmail&source=g> > [email protected] | http://www.packetflux.com > <http://www.linkedin.com/in/fwchristian> <http://facebook.com/packetflux> > <http://twitter.com/@packetflux> > >
