I haven't done that in a few years, but I think the auto update IP will
be the IP address of your workstation. The SM will need to be able to
download the files direct from your IP. You can make that work with NAT
rules, or put your workstation into a DMZ, or give your workstation a
public IP temporarily.
I've been using Maestro and haven't looked back.
------ Original Message ------
From: "Sam Lambie" <[email protected]>
To: [email protected]
Sent: 4/20/2018 12:38:20 PM
Subject: Re: [AFMUG] CNUT not updating SM's via auto update
If I leave it at 0.0.0.0 it should update from any IP right?
On Thu, Apr 19, 2018 at 7:02 PM, Philip Rankin <[email protected]>
wrote:
Sam, there used to be a field on the front page of the cambium
software that set out the upgrade IP address of the computer that was
upgrading the subscriber bottle. That has to be sent to the correct
IP of the upgrading computer or at least the network. Good luck
On Thu, Apr 19, 2018 at 4:16 PM Sam Lambie <[email protected]>
wrote:
Hey all, I am using a NAT'd computer on our work lan and can access
all the AP's from this box. However, when I enable auto update to
upgrade the SM's first, Nothing happens. It used to work fine and in
the past few months it has not.
Any suggestions?
--
--
Sam Lambie
Taosnet Wireless Tech.
575-758-7598 Office
www.Taosnet.com <http://www.newmex.com>
--
Phil
Philip J. Rankin, CEO
Wireless Telecommunications, Corp.
A division of;
Mobilcom Wireless Services
PO Box 24
Pittsburg, KS 66762
620-231-8188
--
--
Sam Lambie
Taosnet Wireless Tech.
575-758-7598 Office
www.Taosnet.com <http://www.newmex.com>
