Matt, exactly which card is that? Is that gas-tube only? I did some
extensive testing at a site yesterday for Chuck. The more data we can
give him the better we'll all be.
On 5/9/2018 9:08 AM, Matt wrote:
Chuck,
Like form factor of new arrestors much better. Thicker PCB and RJ45
not as tall. They do not fit well next to your last thin pcb version
though. Did not care for the thin pcb and tall RJ45 at all. Swapped
out 4 PxP450i APC arrestors to these 17 hours ago. So far flawless
even at 1000base. No errors at all. This is with RackInjector,
Cambium Sync and very long cat-5 runs. Time will tell but looks good
so far.
On Wed, Apr 4, 2018 at 10:29 AM, <[email protected]> wrote:
Matt,
I sent you a note off-list. I would like to send you the gas tube version
to see if that fixes the issue.
Inquiring minds want to know...
-----Original Message----- From: Matt
Sent: Wednesday, March 28, 2018 4:08 PM
To: [email protected]
Subject: Re: [AFMUG] mccowntech rack mount surge suppressor with Medusa
OK, so grounds are related to the problem.
There may be something unusual with timing pulses on the power that is
causing the surge suppressor to fire.
Forrest would know much more than I about that.
I honestly don’t know if anyone has tried my product with a Medusa before.
I have a 100% gas tube version that may solve the problem.
I am still having some troubles with PTP450i holding 1gbit ethernet
even with Cambium sync. Not near as bad with Cambium Sync though.
Will these gas tube versions work any better? Will they still keep
equipment safe?
