Six cables through one hole - don't want any more holes than necessary
in the water tower. I figure it will be easier to drill the one larger
hole, too.
I had not thought about using a bulkhead connector. At this point, that
seems like the best solution.
On 5/25/2018 11:16 PM, Steve Jones wrote:
you want six cables in one hole or 6 holes? 1/2 inch glands is what i
use on single cables, available at any hardware store, they have like
3/4" thread, so the lock nut would affix. Theyre cheaper in bulk than
a hardware store, like 6 for 30 bucks at hardware store or 50 for 100
bucks in bulk online
On Fri, May 25, 2018 at 3:48 PM, Bill Prince <[email protected]
<mailto:[email protected]>> wrote:
A 1" conduit bulkhead connector will do the trick. Attach a short
length of conduit on the outside with a sweep.
If the nipple on the bulkhead connector is not long enough, you
can get longer nipples at any hardware store (1" though 3 or 4
inches).
bp
<part15sbs{at}gmail{dot}com>
On 5/25/2018 1:43 PM, Mike Davis wrote:
Any suggestions on where to get a cable wall pass-through for a
1/2" steel plate? I am out of ideas of where to try. I need to
get 6 cat cables from the inside of a water tower to the outside
at the top of the tower.
--
*Mike Davis*
General Manager
Office: 260-349-1799
Email: [email protected]
<mailto:[email protected]>_
*Alliance Internet Communications* | www.allianceinternet.net
<http://www.allianceinternet.net>
PO Box 1100 | 1220 South Wayne Street | Angola, IN | 46703
<https://maps.google.com/?q=1220+South+Wayne+Street+%7C+Angola,+IN+%7C+46703&entry=gmail&source=g>
| 260-349-1799
