Eh, the front will get there, eventually. You or somebody else, really should grab my bumper while it's still available. Anybody? Anybody? Beuller?
bs Sent from my iPad On May 28, 2011, at 9:33 AM, Jon Kligerman <[email protected]> wrote: > Brian: > > Thanks for the suggestion. I've been told since I posted my request on the digest that the front and back 'rubber' bumpers are made of steel with a rubber outer covering. Remember they were supposed to be 5 mph impact resistant. If this is correct, then my rear bumper is rotting, really rusting, from the inside out. I could try and pick as much out as possible and bondo it. > > Thanks for the front bumper offer, right now my front bumper is in very good condition. It's the rear only that is a problem. > > Thanks very much for your reply. > > Jon Kligerman > > > ----- Original Message ----- From: "Brian Shorey" <[email protected]> > To: "Jon Kligerman" <[email protected]> > Cc: "alfa-digest" <[email protected]> > Sent: Friday, May 27, 2011 4:41 PM > Subject: Re: [alfa] Rubber Bumper Issue > > > I think the internals are rotting away. I'd chisel out what you can, then fiberglass or bondo the rest and paint it. > > I've got a very good condition front bumper for your car, but it's located in the Boston area.. > > bs > > Sent from my iPad > > On May 27, 2011, at 1:21 PM, Jon Kligerman <[email protected]> wrote: > >> Alfisti: >> >> I have a 1982 Spider and it has rubber bumpers front and back. >> >> The car is in good overall condition, including, I though, the bumpers. I >> noticed that one end of the rear bumpers seemed to be pulling away and upon a >> close look the bottom rear of the bumper, that is the side facing the body, is >> split and the inside seems coming out. The material seems to be very hard >> sheets and it is almost as if the bumper is rotting from the inside out. The >> car has not been hit, I should not be as a result of damage. >> >> I know that Bondo has a rubber bumper repair product, which I was going to >> use, before I noticed the extent of the splitting. I could probably try and >> clamp the bumper back together, it might mean removing some of the hard >> 'sheets' from inside, but if I am correct that it is rotting, I'm not sure >> what what should be done. I don't think you can get a new replacement any >> longer. >> >> Does this make sense to any one and has anyone seen this in their car? Does >> anyone know if there any way of repairing what I have? Does anyone know if >> there Is there anything I might do to retard further deterioration? >> >> Thanks very much! >> >> Jon Kligerman >> 1982 Spider Veloce >> -- >> to be removed from alfa, see http://www.digest.net/bin/digest-subs.cgi >> or email "unsubscribe alfa" to [email protected] -- to be removed from alfa, see http://www.digest.net/bin/digest-subs.cgi or email "unsubscribe alfa" to [email protected]
