Thanks, Biba! -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of [email protected] Sent: Monday, July 15, 2013 12:48 PM To: AD Subject: [alfa] Thermostatic actuator question
I assume you've screwed the adjusting screw which is below the TA in as far as it will go. If so, get some various thicknesses of gasket material and cut to fit. I use a sharp Xacto knife to cut the inner circles and scissors for the outer edge. Unless you have the (I believe) Shankle TA adjusting tool, there will be some trial and error unless you're very lucky. Biba Irwindale, CA USA -- to be removed from alfa, see http://www.digest.net/bin/digest-subs.cgi or email "unsubscribe alfa" to [email protected] -- to be removed from alfa, see http://www.digest.net/bin/digest-subs.cgi or email "unsubscribe alfa" to [email protected]
