To comment on the following update, log in, then open the issue: http://www.openoffice.org/issues/show_bug.cgi?id=76212 Issue #|76212 Summary|hatching works bad for 3d objects Component|Drawing Version|OOo 2.2 Platform|All URL| OS/Version|All Status|UNCONFIRMED Status whiteboard| Keywords| Resolution| Issue type|DEFECT Priority|P3 Subcomponent|code Assigned to|wg Reported by|regina
------- Additional comments from [EMAIL PROTECTED] Mon Apr 9 21:50:08 +0000 2007 ------- Draw a 3cmx3cm rectangle. Apply a single line hatching with line distance 0,5cm and 0 degrees. At 100% zoom you will see 5 lines. Now extrude it. Expected behavior: The object has 5 lines on the front as in flat. Seen behavior: There are no lines at all but only fragments in wrong spacing. Zoom in to 400%. You see that there are lines but with wrong spacing. There is always an error, independent of the projection mode for texture, and independent of using traditional shapes or custom shapes or 3d fontwork form objects. The appearance is worse for 3d boxes in charts, both in old chart and in new chart. It seems to me as if a little bitmap is generated and applied to the 3d objects with tile mode instead of generating a bitmap in the same size as the object. On the other hand, using a texture is a bad method at all, because the 3d object can not show the object color through the hatching. Therefore a new method is needed for hatching 3d objects. --------------------------------------------------------------------- Please do not reply to this automatically generated notification from Issue Tracker. Please log onto the website and enter your comments. http://qa.openoffice.org/issue_handling/project_issues.html#notification --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED] --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]
