At Wed, 07 Jan 2004 18:50:42 +0100, Dominik 'Aeneas' Schnitzer wrote: > > On Mit, 2004-01-07 at 18:07, Takashi Iwai wrote: > > the switch of "SB Live Analog/Digital" can be removed if it works for > > you. it was set to make sure the center "analog" jack works. > > (in the recent models, the digital out is shared with the center/lfe > > jack.) > > with my emu10k1 board, i don't get any valid signals over > > center/digital jack unless AC3 is played. it might depend on the > > receiver. perhaps creative has its own protocol? > > > > but, anyway, "Wave Surround" and "Wave Center" don't make sense at > > all. they are volumes of duplicated signals. the volumes of > > surround/center/lfe channels are different mixer elements. > > Hi, > > I just rechecked everyting. You're right, it's just the "SB Live Analog/Digital" > switch/lock to "0" in EMU10K1.conf which needs to be removed, to make things work. > (I'm using a Creative Cambridge SoundWorks DTT3500 receiver, my sblive/emu10k1 card > has revision 07 (lspci)) > > As you pointed out, using the surround/center/lfe/wave volume controls everything > can be > controlled. The WAVE* volume controls-stuff isn't neccessary. > > So basically it boils down to...
ok, then i'll comment out this part on the cvs. thanks for the confirmation. Takashi ------------------------------------------------------- This SF.net email is sponsored by: Perforce Software. Perforce is the Fast Software Configuration Management System offering advanced branching capabilities and atomic changes on 50+ platforms. Free Eval! http://www.perforce.com/perforce/loadprog.html _______________________________________________ Alsa-devel mailing list [EMAIL PROTECTED] https://lists.sourceforge.net/lists/listinfo/alsa-devel
