If you're really careful with the SMA connector, you can make a solder bridge between the connector and the pad rather than using a thin wire. This might be a bit more rugged; there should be minimal flex when the SMA connector is grounded to the board.
Doug On Thu, Jun 15, 2017 at 5:26 PM Chris Attebery <[email protected]> wrote: > Hi Guys, > > The antenna pad on my TM V2 was ripped off the board during a hard landing > last month. My plan is to epoxy the pad back onto the board and then solder > a thin wire from the output of C177/U174 to the antenna wire. I've also > thought that converting the board to an SMA connector might be a more > rugged solution. > > Any suggestions? > > Thanks, > > > Chris > _______________________________________________ > altusmetrum mailing list > [email protected] > http://lists.gag.com/mailman/listinfo/altusmetrum >
_______________________________________________ altusmetrum mailing list [email protected] http://lists.gag.com/mailman/listinfo/altusmetrum
