On Fri, 23 Mar 2001, Jason Hollinden wrote:
> One that I know of it to be sure and grap the newest CVS version of
> chg-zd-mtx.sh.in, as the one that ships with 2.4.2p1 will not handle
> more than 9 tapes.
Done this.
On a related note, I've built and installed mtx-1.2.10 and it produces the
following with the SunOS 5.8 'sgen' driver configured and bound
successfully to the changer device set to ID 5:
7 root@lios #----> mtx -f /dev/scsi/changer/c0t5d0 inquiry
mtx: I/O error
mtx: Request Sense: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
mtx: INQUIRY Command Failed
There is a hard drive on the same SCSI bus (it's the Amanda spool disk,
but isn't used for anything else), and I'm suspecting it might be causing
the problems because I'm seeing a lot of 'target did not disconnect after
sending DISCONNECT' messages in the console window.
Has anyone else successfully used amanda with mtx and the SunOS 'sgen'
driver? I'm going to try removing the drive off the same bus as the
changer to try and isolate the problems. Perhaps I should use the 'sst'
driver instead if that's known to work better?
The hard drive could be defective too.
Regards,
Craig.
--
Craig Dewick. Send email to "[EMAIL PROTECTED]"
Point a web browser at 'http://lios.apana.org.au/~cdewick/sun_shack.html' to
access my archive of Sun information and links to other places. For info
about Sun Ripened Kernels, go to "http://www.sunrk.com.au"
