At 20:50 26/06/2001 +0000, Matt Fearnow <[EMAIL PROTECTED]> wrote:
>I am new to amanda, and have read through all the emails regarding DLT
>autoloader support. I have to admit I am totally confused now. I am not
>sure if I should use chg-multi, chg-scsi, or even chg-zd-mtx I have seen
>all of these referenced concerning DLT autoloaders.
>
>So after reading through these threads I have tried each of the above and
>have not had any success on any of them. I am currently running RH 7.1
>kernel 2.4.2-2smp
The advice to use chg-zd-mtx is good as this is a supported part of amanda.
However when this question was asked a few months ago, Chris Pascoe posted
a changer script called "chg-csee-mtx" which I am using in an almost
identical setup to yours (I am using amanda 2.4.2p1 and RH7.1 on a Dell
2450 with a Powervault 120T Autoloader of which I am only using the first 5
slots). I did have to make one minor change to this script -- there was a
typo in that a > and become a <, if I remember correctly.
If you get nowhere with chg-zd-mtx, come back to me off list.
Chris Ritson
--
EMAIL: [EMAIL PROTECTED] POST: Chris Ritson,
PHONE: +44 191 222 8175 Department of Computing Science,
FAX : +44 191 222 8232 University of Newcastle upon
Tyne,
ROOM: 618 Claremont Bridge (the Mill) United Kingdom NE1 7RU.
