On Mon, 2002-06-10 at 10:37, Craig Hancock wrote: > Hello all I have a Overlan Ait-3 Library Pro. I beileve I have everything > configured. When I attempt to issue a command such as amtape config update > > I always get this error could not load slot 2: Drive not ready after 120 seconds, >rewind said "/dev/st0: Input/output error" > > I also get the same error when I run amlabel > > I am using the chg-zd-mtx Tape changer with one config > > > If anyone can provide any assitance I'd greeatly appriciate it.
The only recommendation about overland changers I can make is to check on the front-panel menus and see if it is set to SCSI-3 or SCSI-2 mode; try SCSI-2, as it seems to reject the SCSI-2 commands in SCSI-3 mode (which is not, to my knowledge how the standard reads, I think SCSI-3 commands are in *addition* to the SCSI-2 ones, but...)
