Tien, if recalibration is what I need
then, looking at my manual, it'd seem that this might be what I wanna do: Uncal Drive Target Allows the operator to uncalibrate a drive target. The next time a tape mount operation is called for that drive, the library recalibrates the target automatically as, for example, when a drive has been physically removed and replaced while the library is operating (hot swapped-only for qualified service personnel). Do you agree? -----Original Message----- From: Tien That Ton [mailto:[EMAIL PROTECTED]] Sent: Thursday, September 12, 2002 3:35 AM To: [EMAIL PROTECTED] Subject: Re: Working with multiple tape drives----- Ammended Reply With History On the library, sometimes due to transportation (and the library was not "Park" properly), the robot arm tends to miscalculate its "Y" position. That is when you need to re-calibrate. By re-calibrate I meant accessing the menu on the library and manually calibrate. On the units that we (Tandberg Data) sell, there is a special menu where you can select to manually calibrate the robot arm. This menu is NOT for normal user use, therefore its need a combinations of keys presses to make it appeared. What I would suggest for you to do is to get the manual for the library you have, maybe there is a section in there that tell you how to recalibrate. If not then you need to contact the support section. Regards Tien
