No.. I have only waited a few hours at a time, but it appears to just sit there.
If I kill the taper process, everything shuts down "normally", but the email says there was a taper protocol error and nothing was written. I turned on taper_debug in my amanda.conf, but that didn't seem to produce any extra output. I have also snooped around various log files, but I don't see any clues. On Mon, Sep 13, 2010 at 07:38:35PM -0500, Dustin J. Mitchell wrote: > The warning is harmless, and has been fixed in trunk. > > On Mon, Sep 13, 2010 at 5:32 PM, Stephen Corbesero <[email protected]> wrote: > > Sun Sep 12 10:29:05 2010: taper: Amanda::Taper::Scribe setting up a > > transfer with split method none > > Sun Sep 12 10:29:05 2010: taper: Starting <x...@0x29f792b0 > > (<xfersourcehold...@0x284ca800> -> <xferdesttapersplit...@0x29a37820>)> > > Sun Sep 12 10:29:05 2010: taper: Final linkage: > > <xfersourcehold...@0x284ca800> -(PULL_BUFFER)-> > > <xferelementg...@0x29a38038> -(PUSH_BUFFER)-> > > <xferdesttapersplit...@0x29a37820> > > This is a FILE-WRITE - a write from holding disk - so there's no > connection to the dumper required. It looks like this was running > fine up until this point. Did it never terminate? If so, can you > tell what it was doing via gdb or strace? > > Dustin > > -- > Open Source Storage Engineer > http://www.zmanda.com -- Stephen Corbesero It's always darkest Bethlehem, PA 18015 before pitch black. [email protected]
