On Tue, Nov 20, 2018 at 1:51 PM Chris Nighswonger < [email protected]> wrote:
> On Tue, Nov 20, 2018 at 1:45 PM Chris Miller <[email protected]> wrote: > >> Hi Chris, >> >> *From: *"Chris Nighswonger" <[email protected]> >> *To: *"Chris Miller" <[email protected]> >> *Cc: *"amanda-users" <[email protected]> >> *Sent: *Tuesday, November 20, 2018 9:56:12 AM >> *Subject: *Re: Taper scan algorithm did not find an acceptable volume. >> >> On Tue, Nov 20, 2018 at 10:58 AM Chris Miller <[email protected]> wrote: >> >>> Hi Jon, >>> <SNIP> >>> This is confirmed. From my AMANDA server, I can see each of my NAS as a >>> SaMBa share. I can ping each of my clients from the AMANDA server, and >>> smbclient -L let's me browse their filesystems. >>> >> >> And amcheck <CONFIG> says? >> >> amcheck reports the following for each of the three clients in my test >> config: >> >> Amanda Tape Server Host Check >> ----------------------------- >> NOTE: Holding disk '/var/amanda/hold': 2720485376 KB disk space >> available, using 2720485376 KB >> slot 0: contains an empty volume >> <SNIP> >> slot 28: contains an empty volume >> all slots have been loaded >> Taper scan algorithm did not find an acceptable volume. >> (expecting a new volume) >> ERROR: No acceptable volumes found >> Server check took 1.036 seconds >> > > amcheck also checks the clients. I see no output here to indicate that > amanda is able to connect to your clients. Was there no client related > output or did you snip it out? > For example (limited to one host just to illustrate): backup@scriptor:/amcheck -c campus host.fqdn Amanda Backup Client Hosts Check -------------------------------- Client check: 1 host checked in 2.119 seconds. 0 problems found. (brought to you by Amanda 3.3.6) backup@scriptor:/
