Ozzy --
Yes, at this point it seems to be easier to live with all the extra
columns than to learn how OLE works.
I believe, long ago, before the suggestion page was implemented on AB
site, that I suggested to TJ that no columns be displayed by default,
and that the all columns and their widths be specified programmatically
and/or in a settings page. Obviously the suggestion was not
implemented. IMHO, it would be a significant improvement over the
present system.
I did get your previous response. But I understand your concern. I had
to post my request three times before it finally went through. My two
others were on 1/14, 1:04am and 1/16, 1:39am. Just recently these were
finally delivered. Yahoogroups can be unbelievably slow at times.
-- Keith
ozzyapeman wrote:
Seems my response did not go thru. Reposting:
Keith - did not get around to implementing any OLE. Living with the
extra columns for now. But if I do write any code for it, will post it
here in the future.
--- In [email protected] <mailto:amibroker%40yahoogroups.com>,
Keith McCombs <kmcco...@...> wrote:
>
> Ozzy --
> Any chance you have already gone through the pain of implementing the
> appropriate OLE code. If so, would it be possible to share it and some
> brief instructions on how to use it? That would be greatly appreciated.
>
> Thank you.
> -- Keith
>
> ozzyapeman wrote:
> >
> > I asked this Q on the board a few weeks ago, and the consensus was
"no".
> >
> > But you can export the report using OLE and run an exploration showing
> > only the columns you want:
> >
> > http://finance.groups.yahoo.com/group/amibroker/message/132540
<http://finance.groups.yahoo.com/group/amibroker/message/132540>
> > <http://finance.groups.yahoo.com/group/amibroker/message/132540
<http://finance.groups.yahoo.com/group/amibroker/message/132540>>
> >
> > --- In [email protected] <mailto:amibroker%40yahoogroups.com>
<mailto:amibroker%40yahoogroups.com>,
> > "huanyanlu" <huanyan2000@> wrote:
> > >
> > > Hi,
> > >
> > > I just learned to add some custom metrics into backtester. But
then I
> > > find that some of the built-in metrics in the backtester are not
> > > important in my way of analysis. So is there a way to show only
some of
> > > the built-in metrics , together with my added custom metrics ?
> > >
> > > According to the help file, it seems that the backtester object can
> > > allow you either show all the built-in metrics, or not show any of
> > > them .
> > >
> > > Thanks for any help
> > >
> > > Huanyan
> > >
> >
> >
>
