Keith Concerning Yahoo, many times my mails appeared 4 days later. Once, 6 days later. This sluggishness happens every time I post throught Thunderbird. Via Web, it seems OK.
Best regards --- In [email protected], Keith McCombs <kmcco...@...> wrote: > > Ozzy -- > Yes, at this point it seems to be easier to live with all the extra > columns than to learn how OLE works. > > I believe, long ago, before the suggestion page was implemented on AB > site, that I suggested to TJ that no columns be displayed by default, > and that the all columns and their widths be specified programmatically > and/or in a settings page. Obviously the suggestion was not > implemented. IMHO, it would be a significant improvement over the > present system. > > I did get your previous response. But I understand your concern. I had > to post my request three times before it finally went through. My two > others were on 1/14, 1:04am and 1/16, 1:39am. Just recently these were > finally delivered. Yahoogroups can be unbelievably slow at times. > -- Keith > > ozzyapeman wrote: > > > > Seems my response did not go thru. Reposting: > > > > Keith - did not get around to implementing any OLE. Living with the > > extra columns for now. But if I do write any code for it, will post it > > here in the future. > > > > --- In [email protected] <mailto:amibroker%40yahoogroups.com>, > > Keith McCombs <kmccombs@> wrote: > > > > > > Ozzy -- > > > Any chance you have already gone through the pain of implementing the > > > appropriate OLE code. If so, would it be possible to share it and some > > > brief instructions on how to use it? That would be greatly appreciated. > > > > > > Thank you. > > > -- Keith > > > > > > ozzyapeman wrote: > > > > > > > > I asked this Q on the board a few weeks ago, and the consensus was > > "no". > > > > > > > > But you can export the report using OLE and run an exploration showing > > > > only the columns you want: > > > > > > > > http://finance.groups.yahoo.com/group/amibroker/message/132540 > > <http://finance.groups.yahoo.com/group/amibroker/message/132540> > > > > <http://finance.groups.yahoo.com/group/amibroker/message/132540 > > <http://finance.groups.yahoo.com/group/amibroker/message/132540>> > > > > > > > > --- In [email protected] <mailto:amibroker%40yahoogroups.com> > > <mailto:amibroker%40yahoogroups.com>, > > > > "huanyanlu" <huanyan2000@> wrote: > > > > > > > > > > Hi, > > > > > > > > > > I just learned to add some custom metrics into backtester. But > > then I > > > > > find that some of the built-in metrics in the backtester are not > > > > > important in my way of analysis. So is there a way to show only > > some of > > > > > the built-in metrics , together with my added custom metrics ? > > > > > > > > > > According to the help file, it seems that the backtester object can > > > > > allow you either show all the built-in metrics, or not show any of > > > > > them . > > > > > > > > > > Thanks for any help > > > > > > > > > > Huanyan > > > > > > > > > > > > > > > > > > > > >
