Yes, that'll work. You'll make your head hurt getting it all set up tho :)
Quick outline of approach: 1) get AWGPE installed and working. 2) install a virtual serial port pair using something like com0com; use baud emulation. 3) install AGWPE KISS-Mode Loopback interface. Configure to use one of the virtual ports; use 9600 baud. 4) Now launch/configure F-1 Telemetry decoder. Pick "the other" virtual com port, use 9600 baud, and then start it. Use local APRS packet traffic to test...you should be printing it (raw data.... It takes a bit of monkey-ing around, but it works! 73, Mark N8MH At 12:29 PM 9/30/2012 -0400, Mark L. Hammond wrote: >Hi Keith, > >It's apparently setup to use hardware modems. This shack loves hardware TNCs >:) > >You might be able to get AWGPE working if you can send KISS data out to a >virtual com port...check out http://www.soundcardpacket.org/ > >"In addition, Tim Pearson KB9VQF has written a ><http://www.pearsoncomputing.net/freeware.php>AGWPE Serial Loopback utility >that creates virtual serial ports that will let you link AGWPE to any packet >program that can link to a KISS-enabled TNC (AGWPE's sound card mode simulates >a KISS TNC). " > > > >73, > >Mark N8MH > >At 09:04 AM 9/30/2012 -0700, Keith O'Brien wrote: >>The F1 Telemetry Decoder Manual in Section 5.2.3 Decode Data OBC2 >>*You should connect this program with your transceiver first. >> >>Not sure what they are looking for here. I would like to use AGW Packet >>Engine >>as my packet TNC. Anyone offer any guidance in how to configure APWPE to the >>F1 decoder program ? I also have MixW if that would work... >> >>Keith N4ZQ >> >> >>_______________________________________________ >>Sent via [email protected]. Opinions expressed are those of the author. >>Not an AMSAT-NA member? Join now to support the amateur satellite program! >>Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb _______________________________________________ Sent via [email protected]. Opinions expressed are those of the author. Not an AMSAT-NA member? Join now to support the amateur satellite program! Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb
