A curious problem. Analog 3.32 (on Win98) has been running fine but I
decided to upgrade to 4.0. The program crashes after analysing the two log
files (one of 11 Mb, one of 19Mb) and gives the following message
This program has performed an illegal operation:
ANALOG caused an invalid page fault in
module ANALOG.EXE at 023f:0041a0d0.
But it only does this when analysing *both* log files in the same operation.
If I analyse the first one on its own there is no problem, and the same with
the second one.
The entries in the analog.cfg file that I think are relevant are as follows:
############################
# Following commands needed to read the two formats contained
# in our log files. Do not remove.
LOGFORMAT COMMON
LOGFORMAT COMBINED
# log files below named access_log1, access_log2 etc are older log files
# the log file without a number is the current log file
LOGFILE britan.palnet.com_access_log1
LOGFILE britan.palnet.com_access_log
############################
The cfg file was the same as I used on version 3.32 only modified to reflect
new file locations.
I tried reinstalling but the problem persists. I'd be grateful for any
suggestions.
Rob Elliott
Jerusalem
[EMAIL PROTECTED]
http://www.britishconsulate.org
------------------------------------------------------------------------
This is the analog-help mailing list. To unsubscribe from this
mailing list, send mail to [EMAIL PROTECTED]
with "unsubscribe analog-help" in the main BODY OF THE MESSAGE.
List archived at http://www.mail-archive.com/[email protected]/
------------------------------------------------------------------------
