Frank,
Assuming your reply was to my suggestion about running analog -settings,
that means from a command prompt, navigate to your analog directory
(d:\analog in my case) and type
analog -settings
at the command prompt. This will display all the settings Analog would use
if run without that keyword. If it scrolls off the top of your screen try:
analog -settings | more
which should then page the output into screens full.
BTW, Have you been running it from the command prompt, or double-clicking on
an icon? Running it from an icon is _NOT_ a good way to get started - it can
conceal what is really going on by flashing a screen on then off which
otherwise has very extensive error and warning messages to help track down
problems. The command prompt is usually found at Start | Programs | Command
Prompt (or on ME at: Start | Programs | Accessories | Command Prompt)
Simon West
-----Original Message-----
From: f.reynolds [mailto:[EMAIL PROTECTED]]
Sent: 12 February 2001 16:29
To: '[EMAIL PROTECTED]'
Subject: RE: [analog-help]
Sorry - not sure what that is or how to do it.
Frank
------------------------------------------------------------------------
This is the analog-help mailing list. To unsubscribe from this
mailing list, send mail to [EMAIL PROTECTED]
with "unsubscribe" in the main BODY OF THE MESSAGE.
List archived at http://www.mail-archive.com/[email protected]/
------------------------------------------------------------------------
------------------------------------------------------------------------
This is the analog-help mailing list. To unsubscribe from this
mailing list, send mail to [EMAIL PROTECTED]
with "unsubscribe" in the main BODY OF THE MESSAGE.
List archived at http://www.mail-archive.com/[email protected]/
------------------------------------------------------------------------
