Hi Saga, Actually there is.
The configuration is being applied using source templates. Regards, Lucio Jankok Op vr 4 feb. 2022 om 11:01 schreef Sagar Paul <[email protected]>: > > Hey Lucio, > as I see in the config that you have shared, there is no switchport or > vlan data to parse as per the current scope of the module. > Note - > the interface data as shared in the above config is > ``` > interface GigabitEthernet0/0 > vrf forwarding Mgmt-vrf > no ip address > shutdown > negotiation auto > ! > interface GigabitEthernet1/0/1 > no logging event link-status > no cdp enable > no snmp trap link-status > source template redacted > service-policy input redacted > ! > interface GigabitEthernet1/0/2 > no logging event link-status > shutdown > no cdp enable > no snmp trap link-status > source template redacted > service-policy input redacted > ! > ! > interface GigabitEthernet1/0/24 > shutdown > ! > interface GigabitEthernet1/1/1 > ! > interface GigabitEthernet1/1/2 > ! > interface GigabitEthernet1/1/3 > ! > interface GigabitEthernet1/1/4 ``` the module is supposed to generate > blank facts for the device. Regards, Sagar Paul > *E - [email protected] <[email protected]> GH - KB-perByte* > > On Tuesday, February 1, 2022 at 9:14:29 PM UTC+5:30 [email protected] > wrote: > >> Hi Sagar, >> >> The following is the case: >> >> *With the following platform I have no issues* >> >> platform: cisco WS-3850-24S >> net_iostype: IOS-XE >> net_version: 16.06.05 >> >> output: >> net_interfaces - show me interface configuration per interface >> net_neighbors - shows me Mac address etc for all connected devices >> l2_interfaces - shows me interface name, switchport mode and access vlan >> >> --- >> >> *With the 9300 I don't get the complete l2_interfaces output* >> >> *platform: 9300-24p* >> *net_iostype: IOS-XE* >> *net_version: 17.03.03* >> >> net_interfaces - show me interface configuration per interface >> net_neighbors - shows me Mac address etc for all connected devices >> l2_interfaces - shows me only interface name. *missing switch port mode >> and access vlan* >> >> ---- >> >> *Here is the redacted config for the 9300* >> >> Building configuration... >> >> >> >> Current configuration : 30751 bytes >> >> ! >> >> ! >> >> version 17.3 >> >> service tcp-keepalives-in >> >> service timestamps debug datetime msec localtime show-timezone >> >> service timestamps log datetime msec localtime show-timezone >> >> service password-encryption >> >> service compress-config >> >> service call-home >> >> no platform punt-keepalive disable-kernel-core >> >> ! >> >> hostname redacted >> >> ! >> >> ! >> >> vrf definition Mgmt-vrf >> >> ! >> >> address-family ipv4 >> >> exit-address-family >> >> ! >> >> address-family ipv6 >> >> exit-address-family >> >> ! >> >> logging discriminator CFGLOG mnemonics drops CFGLOG_LOGGEDCMD >> >> logging buffered discriminator CFGLOG 16384 informational >> >> no logging console >> >> enable secret 9 redacted >> >> ! >> >> aaa new-model >> >> ! >> >> ! >> >> aaa group server tacacs+ AUTH >> >> server name redacted >> >> server name redacted >> >> ip tacacs source-interface redacted >> >> ! >> >> aaa authentication password-prompt "Local Password: " >> >> aaa authentication username-prompt "Local Username: " >> >> aaa authentication login default group AUTH local >> >> aaa authentication enable default group AUTH enable >> >> aaa authorization console >> >> aaa authorization config-commands >> >> aaa authorization exec default group AUTH local >> >> aaa authorization commands 1 default group AUTH if-authenticated >> >> aaa authorization commands 15 default group AUTH if-authenticated >> >> aaa accounting exec default start-stop group AUTH >> >> aaa accounting commands 15 default stop-only group AUTH >> >> ! >> >> ! >> >> ! >> >> ! >> >> ! >> >> ! >> >> aaa session-id common >> >> boot system switch all flash:packages.conf >> >> clock timezone CET 1 0 >> >> clock summer-time CEST recurring last Sun Mar 2:00 last Sun Oct 3:00 >> >> switch 1 provision c9300-24p >> >> switch 2 provision c9300-24p >> >> software auto-upgrade enable >> >> ! >> >> ! >> >> ! >> >> ! >> >> ! >> >> ! >> >> ! >> >> ! >> >> ! >> >> ! >> >> no ip domain lookup >> >> ip domain name redacted >> >> ! >> >> ! >> >> ! >> >> ip dhcp snooping vlan redacted >> >> no ip dhcp snooping information option >> >> ip dhcp snooping >> >> login on-success log >> >> ! >> >> ! >> >> ! >> >> ! >> >> ! >> >> ! >> >> ! >> >> vtp mode off >> >> udld enable >> >> >> >> no device-tracking logging theft >> >> password encryption aes >> >> ! >> >> source template redacted >> >> ! >> >> ! >> >> ! >> >> ! >> >> ! >> >> port-channel load-balance src-dst-ip >> >> license boot level network-advantage addon dna-advantage >> >> license smart url cslu redacted >> >> ! >> >> ! >> >> diagnostic bootup level complete >> >> ! >> >> spanning-tree mode rapid-pvst >> >> spanning-tree portfast bpduguard default >> >> spanning-tree extend system-id >> >> spanning-tree pathcost method long >> >> archive >> >> log config >> >> logging enable >> >> notify syslog contenttype plaintext >> >> path redacted >> >> write-memory >> >> memory free low-watermark processor 133138 >> >> ! >> >> errdisable recovery cause udld >> >> errdisable recovery cause bpduguard >> >> errdisable recovery cause channel-misconfig >> >> errdisable recovery cause link-flap >> >> errdisable recovery cause gbic-invalid >> >> errdisable recovery cause psecure-violation >> >> errdisable recovery cause loopback >> >> errdisable recovery interval 600 >> >> username redacted privilege 15 secret 9 redacted >> >> ! >> >> redundancy >> >> mode sso >> >> ! >> >> ! >> >> ! >> >> ! >> >> ! >> >> ! >> >> transceiver type all >> >> monitoring >> >> hw-switch switch 1 logging onboard message >> >> ! >> >> vlan redacted >> >> name redacted >> >> ! >> >> vlan redacted >> >> name redacted >> >> ! >> >> ! >> >> template redacted >> >> spanning-tree portfast >> >> switchport access vlan redacted >> >> switchport mode access >> >> load-interval 30 >> >> description redacted >> >> ! >> >> ! >> >> interface GigabitEthernet0/0 >> >> vrf forwarding Mgmt-vrf >> >> no ip address >> >> shutdown >> >> negotiation auto >> >> ! >> >> interface GigabitEthernet1/0/1 >> >> no logging event link-status >> >> no cdp enable >> >> no snmp trap link-status >> >> source template redacted >> >> service-policy input redacted >> >> ! >> >> interface GigabitEthernet1/0/2 >> >> no logging event link-status >> >> shutdown >> >> no cdp enable >> >> no snmp trap link-status >> >> source template redacted >> >> service-policy input redacted >> >> ! >> >> ! >> >> interface GigabitEthernet1/0/24 >> >> shutdown >> >> ! >> >> interface GigabitEthernet1/1/1 >> >> ! >> >> interface GigabitEthernet1/1/2 >> >> ! >> >> interface GigabitEthernet1/1/3 >> >> ! >> >> interface GigabitEthernet1/1/4 >> >> ! >> >> i >> >> ! >> >> line con 0 >> >> exec-timeout 30 0 >> >> logging synchronous >> >> stopbits 1 >> >> line vty 0 4 >> >> access-class ACL-VTY in >> >> exec-timeout 30 0 >> >> logging synchronous >> >> transport input ssh >> >> line vty 5 31 >> >> access-class ACL-VTY in >> >> exec-timeout 30 0 >> >> logging synchronous >> >> no exec >> >> transport input ssh >> >> ! >> >> end >> >> >> Op ma 31 jan. 2022 om 13:36 schreef Sagar Paul <[email protected]>: >> >>> Hi Lucio, >>> >>> Can you please share the config that is not giving facts data? >>> >>> Regards, >>> Sagar Paul >>> >>> On Friday, January 28, 2022 at 10:25:49 PM UTC+5:30 [email protected] >>> wrote: >>> >>>> Hi, >>>> >>>> When I use the gather fact module and choose to get the l2_interfaces, >>>> it doesn't return the l2_interfaces properties. >>>> When I use the same playbook on catalyst 3650 (also ios-xe) I get the >>>> l2_interfaces properties. >>>> >>>> Is this a known issue? >>>> >>>> Regards, >>>> >>>> Lucio Jankok >>>> >>> -- >>> You received this message because you are subscribed to the Google >>> Groups "Ansible Project" group. >>> To unsubscribe from this group and stop receiving emails from it, send >>> an email to [email protected]. >>> To view this discussion on the web visit >>> https://groups.google.com/d/msgid/ansible-project/674592ac-b9c5-4b76-abba-7b3ebb720819n%40googlegroups.com >>> <https://groups.google.com/d/msgid/ansible-project/674592ac-b9c5-4b76-abba-7b3ebb720819n%40googlegroups.com?utm_medium=email&utm_source=footer> >>> . >>> >> -- > You received this message because you are subscribed to the Google Groups > "Ansible Project" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > To view this discussion on the web visit > https://groups.google.com/d/msgid/ansible-project/3cc4277a-a976-447d-ba2d-255a7cc9525en%40googlegroups.com > <https://groups.google.com/d/msgid/ansible-project/3cc4277a-a976-447d-ba2d-255a7cc9525en%40googlegroups.com?utm_medium=email&utm_source=footer> > . > -- You received this message because you are subscribed to the Google Groups "Ansible Project" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/ansible-project/CADFeZ2u0uOZ%3DpPsxSttjYgH77dKXH33m%3D5iZTaCeJV017Q3Whw%40mail.gmail.com.
