On Thu, 13 Jan 2000 18:50:55 -0500, Glenn McCorkle wrote:
> Hi Michael,
> On that Compaq that loads epppd.exe "high" but still won't place the
> IP adress into ppp.log......
> in arachne.cfg change
> [tcp/ip]
> IP_Address PPP
> to
> [tcp/ip]
> IP_Address BOOTP
> I tried it last evening and it works. The only "problem" was that
> the time-online does not show. Instead it just says "TCP/IP"
Glenn,
Woops, I spoke too soon, As soon as I pressed the "empty trash"
button (not on yours<g>, other posts I didn't keep), my TCP/IP
went OFFLINE right then and there. I had to switch to my other
.acf to get back on. Apparently I don't have enough extra memory
above 640 k with EPPPD loaded high, (about 10K), so there is
some sort of conflict there. I probably need to move dmouse.com
back down to conventional memory. I'll try some combinations to
see what is causing it.
I have been using Netdial 1.3's epppd ahead of Arachne, and I am
now with this .acf, and it works fine to have epppd loaded high.
But in this arachne-only .acf with the changes you recommended,
I have trouble.
Maybe the trouble is with BOOTP, I'm just not sure.
Thanks,
Michael L. Dawley
Pearl, Mississippi
--Arachne 1.50 on IBM PS/1 486SX 25 Mhz 32MB Ram 130MB HDD--
-- Arachne V1.50;s.r.c., NON-COMMERCIAL copy, http://home.arachne.cz/
