Hi Richard! Thanks for your messsage. :) You wrote: >I was unsure if the TCP/IP stack had to be loaded or if I could >connect to my network using NetBeui and then connect Arachne to the Internet >using a packet driver. I'm using an NE2000 compatible card and have been >successful loading the packet driver. What I have not been successful at yet >is configuring WATTCP. This is the point (and this takes us to a "gray" area ) Configuring Arachne to work on LAN means providing it an IP address, a gateway and a DNS server. All of these should be stated in Arachne.cfg. Use Arachne setup section to enter them. Do not use the Packet Wizard, use the manual packet driver setup. You may instruct Arachne to use BOOTP, but I am not sure it works. You'll probably have to check the settings of the TCP/IP protocol in Windows (see Network Setup). Are you able to access the Internet from Windows? Tell me how? You must NOT alter wattcp.cfg, unless you instruct Arachne to use it. It is neither necessary, nor recommended. Hope these will be of any use. Cristian Burneci
