On Sat, 26 Jan 2002 06:28:52 -0500 (EST), Thomas Mueller wrote: >> you can make an attempt to play with subj:
>> http://www.phystechsoft.com/free/ptsds32r.zip (size is about 750K). >> The Demo is with 1 minute load delay (announced as full functional). > It's pity but this stuff (installation instruction) is in Russian. > I'm sorry. > But it works (at least being installed on FAT32). My attempt to make it > runnable from PTS-DOS 2000 (FAT16) failed. <snip> > You mean the demo doesn't work at all on a FAT16 partition? I don't have any > FAT32. I have nothing that can display Cyrillic in DOS but might in Linux, > haven't set up yet. I mean that I just wasn't lucky enough to install it on FAT16. Some disk write error occured every time when preparing installation/boot floppy. I'm afraid that Cyrillic support is embedded in installation program :) > If the Rockwell PCI modem is a Winmodem, you're out of luck, buy a hardware > modem. If the Rockwell modem is a hardware modem, you would have to set up for > a nonstandard serial port with the base address and IRQ. Ralf Brown's PCI > program ought to find your PCI base addresses and IRQ. Same information can be > found in /proc/pci if you run Linux. Arachne installation has some information > in DOC\PCIMODEM.HTM from the main Arachne directory. Next question is whether > EPPPD will work. Chat or miniterm should dial if you have the correct base > address and IRQ. You could also try LSPPP. I'll check it, thank you. Regards, - -- Vasily Zatsepin | mailto: [EMAIL PROTECTED] Arachne WWW browser v.1.70 - registered Visit http://arachne.browser.org/ - Web browser for DOS
