Hi,Remember to change the board type;) Also pay attention to the ethernet driver as my board has STE100. VT support is disabled as I find it useless on my board.
BTW, I'm not quite sure, but HAL & D-Bus serve no purpose for you so you may disable them (I might be wrong...). Also aggety seems to be useless, so I disabled console logins in /etc/inittab in my installation.
Config files in attachment. -- Best regards, Andrzej Telszewski On 03/08/2010 09:14 PM, Vitaly V. Ch wrote:
Thanks, Can You give me You config file? I also boot form sd//mmc and have minimalistic system: only a ap d k l n series of packages. Full list of my services: udev, hald, dbus, ssh, cups, agetty. Most of boot time occupied by udev and hald. about 60 sec per each. On Mon, Mar 8, 2010 at 7:47 PM, Andrzej Telszewski <[email protected]> wrote:Hi, All times measured from the point when U-Boot starts to load the kernel image to the point when login prompt shows up: a) my custom kernel (2.6.32.9): ~37s b) your kernel (2.6.31.12): ~48s Things to notice: my system boots from SD/MMC; your kernel is quite more fat that mine (yours size: 1469820, mine size: 1097444; your modules size: 5.5M, my modules size: 3.0). But all in all, the times presented above aren't as big as in your case (to be appropriate add about ~10s for the power up of my board). Maybe you have some services loaded during the start-up? E.g. some scripts for updating fonts indexes, etc. I haven't done the full installation of armed: at least I didn't install: D, E, F, K, KDE, KDEI, T, TCL, X, XAP, Y. Also the A, AP, L and N series are installed only in minimal manner. By the way, aren't you going to switch to 2.6.32? That's the way that Stuart suggested me to go;) It should be straightforward as the patches for AT91 for 2.6.32 recently showed up on http://maxim.org.za/at91_26.html (my board boots even without AT91 patch, even with 2.6.33 - but there might be some things that the system misses without the patch).Thanks, it's interested news. \\wbr Vitaly Chernookiy _______________________________________________ ARMedslack mailing list [email protected] http://lists.armedslack.org/mailman/listinfo/armedslack
config-2.6.31.12.bz2
Description: Binary data
config-2.6.32.9.bz2
Description: Binary data
_______________________________________________ ARMedslack mailing list [email protected] http://lists.armedslack.org/mailman/listinfo/armedslack
