Hello,
I just applied PTFs for the following APAR:
http://www-01.ibm.com/support/docview.wss?uid=isg1PI62275&myns=z000&mynp=OCSWG90&mync=E&cm_sp=z000-_-OCSWG90-_-E
It basically brings in the Z14 instructions into the assembler. Had to
install a couple pre-reqs but everything went well. As far as I can
tell, everything works correctly except when I specify
MACHINE(ZSERIES-7) as a parameter to the assembler. HLASM complains
with "** ASMA400W Error in invocation parameter -
MACHINE(ZSERIES-7,NOLIST)" and it only pops out for ZSERIES-7 and ZS7.
It's happy with everything else including ZSERIES-8/ZS8.
Any ideas as to why it is doing this?
Apologies in advance if this is the wrong list to post this to.
Thanks
Frank
--
Development Programmer
ColeSoft Marketing
www.colesoft.com
Phone : 540.456.6164
Email : [email protected]
