What about define those phones on the SIP.conf and use sip, instead of IAX. That protocol use be more used to communicate Asterisk servers more than phones.
Regards, Carlos Alperin -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Zoltan Szecsei Sent: Thursday, July 07, 2005 12:09 PM To: Asterisk Users Mailing List - Non-Commercial Discussion Subject: [Asterisk-Users] IAXphone -> ip address -> extension number. Hi, I'm trying to set up two ACT SIP/IAX capable phones to communicate with each other on the same internal network, using asterisk 1.0.9 on SuSE 9.3 (because I intend to grow the situation after this basic setup is functioning) The phone IPs are set to 192.168.0.201 and 202 respectively. I've had a look at iax.conf and extensions.conf but cannot see how to tie these IPs to an extension number, let alone how to dial that extension. The "Getting Started with Asterisk" and the "Asterisk Doc Proj - Vol 1" that I have been using just have far too much info to work out what can be ignored in order to get such a simple setup working. I'd be happy for any help or pointers to steps that I should have followed. TIA, Zoltan _______________________________________________ Asterisk-Users mailing list [email protected] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users _______________________________________________ Asterisk-Users mailing list [email protected] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
