Dave Cotton wrote:
On Thu, 2005-07-14 at 09:01 +0200, Zoltan Szecsei wrote:
Ken Godee wrote:
On reboot sometimes my onboard gigabit nic gets eth0 and sometimes
the pci 3COM gets eth0 and this causes havoc with another piece of SW
I run.
I seem to remember having this type of thing before, only I had two
identical NICs, because they were good ones :)
Have you tried creating an alias in modprobe.conf (2.6) or modules.conf
(2.4)
alias eth0 b44
alias eth1 e100
in my case
Hi,
I'm not sure what you are getting at here. An alias is just a second
name for something. If the HW device changes under the original name
(eth0), then surely the alias pointing to that original name now too
points to the different HW device?
Apologies if I have mis-understood you.
I seem to think that what is required is a way (at boot time) to make
certain that the pci slots get probed before the on M/B nic gets probed,
that way ensuring that the pci nic is set up before the on board nic.
Can this be done?
regards,
Zoltan
--
==================================
Geograph (Pty) Ltd
P.O. Box 31255
Tokai
7966
Tel: +27-21-7018492
Fax: +27-86-6115323
Mobile: +27-83-6004028
==================================
_______________________________________________
Asterisk-Users mailing list
[email protected]
http://lists.digium.com/mailman/listinfo/asterisk-users
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
