On Wed, 28 Sep 2005 [EMAIL PROTECTED] wrote: > Hello, > > I am using a system with an AVM ISDN PCI card (fcpci) and asterisk with > chan_capi-cm-0.6. The hardware is connected to a Siemens Hipath 3550 PBX. As a > BRI connection has 2 channels and allows 2 simultaneous calls, numbers/MSNs > 6391 and 6392 were for provisioned for each channel. The system is working > (partly, read on), the trick is the correct cable wiring and setup the PBX's > port as "S0 Euro Bus". > > Calls from asterisk to PBX are working ok, really nice! But calls from PBX to > asterisk are partly working. Calls to 6391 are okay, but calls to 6392 are > not. They simply did not appear on the BRI port (checked with capi debug). > > The problem seems to be something related to MSN routing. The PBX manual says > it is possible to connect up to 64 devices in one S0/BRI port and even show > the wiring diagram for that. However, there is not a clear way to define MSN x > goes to channel 1, MSN y goes to channel 2 in the PBX management software. I > am starting to think it is impossible to configure this through PBX... > > The PBX manual and on-line help says (as far as I understood) MSNs are > configured at the user station.... but, this time, I was unable to configure > MSN x=>channel 1, MSN y=>channel 2 in the capi.conf file of chan_capi which > acts as the station. > > Actually, I am super-confused! Is it possible to configure the MSN routing as > I explained? Is Siemens right, that is, it is up to the station to advertise > it is "reachable" and its MSN? Will chan_capi + fcpci do that?
No, your PBX must be configured to signal a call to these MSNs on that S0 port. In capi.conf you just specify which MSNs shall be signaled to Asterisk. Using incomingmsn=* means all MSNs and the extensions.conf can decide what to do with it. If you have a verbose level of 5 and set 'capi debug', you should see at least a CONNECT_IND message on a call. If you don't see that, than the PBX is not signaling this call on that S0 port. In that case, chan_capi and me cannot help you, it's an PBX issue. Armin _______________________________________________ --Bandwidth and Colocation sponsored by Easynews.com -- Asterisk-Users mailing list [email protected] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
