Re: [Asterisk-Users] TE205P in loopback?

Franciraldo Cavalcante Junior Thu, 29 Sep 2005 09:29:16 -0700

All the config match. Just to make sure, how did you make your loopback cable? Which pins are conected were?

Thanks in advance,

-f

From: "Steve Totaro" <[EMAIL PROTECTED]>
Reply-To: Asterisk Users Mailing List - Non-Commercial Discussion<[email protected]>
To: "Asterisk Users Mailing List - Non-Commercial Discussion"<[email protected]>
Subject: Re: [Asterisk-Users] TE205P in loopback?
Date: Wed, 28 Sep 2005 22:28:02 -0700

It flashes red until the properly made cables are connected and then should turn to solid green. Again, I suspect your cable is the issue. Are all the drivers loaded? ztcfg? Asterisk running? One span set to pri_cpe and the other to pri_net?

----- Original Message -----

From: Franciraldo Cavalcante Junior

To: [email protected]

Sent: Wednesday, September 28, 2005 6:47 PM

Subject: Re: [Asterisk-Users] TE205P in loopback?

The board flashes red without cables and continues flashing red after cables are connected. Should it flash green before? I don't see anything weird in dmegs results.

From: "Steve Totaro" <[EMAIL PROTECTED]>
Reply-To: Asterisk Users Mailing List - Non-Commercial Discussion<[email protected]>
To: "Asterisk Users Mailing List - Non-Commercial Discussion"<[email protected]>
Subject: Re: [Asterisk-Users] TE205P in loopback?
Date: Wed, 28 Sep 2005 21:12:08 -0700

If the cables are connected and the lights are still flashing red then I suspect that the cable is the issue.

----- Original Message -----

From: Franciraldo Cavalcante Junior

To: [email protected]

Sent: Wednesday, September 28, 2005 5:44 PM

Subject: Re: [Asterisk-Users] TE205P in loopback?

I did the cable and configuration as recomended, but I may have another problem. After I run:

modprobe zaptel

modprobe wct2xxp

I don't see the boards flashing green it's flashing red and in sync, as I implicitly understand from your message . Should it flash green and when correctly cabled and configured, keep green?

How can I debug this?

any help is appreciated.

-f

From: "Steve Totaro" <[EMAIL PROTECTED]>
Reply-To: Asterisk Users Mailing List - Non-Commercial Discussion<[email protected]>
To: "Asterisk Users Mailing List - Non-Commercial Discussion"<[email protected]>
Subject: Re: [Asterisk-Users] TE205P in loopback?
Date: Wed, 28 Sep 2005 20:12:40 -0700

I just did this on a te410p.

make a t1 crossover, cross pins one with four, and two with five. Set one span for pri_cpe and the other side for pri_net.  boom, you are done and can start testing. the lights should turn solid green and you should first see the  D channels come up and then all the B channels, if this happens, you have done it correctly.

thanks,

Steve

----- Original Message -----

From: Franciraldo Cavalcante Junior

To: [email protected]

Sent: Wednesday, September 28, 2005 4:46 PM

Subject: [Asterisk-Users] TE205P in loopback?

I'm a new * user and had just intalled A TE205P line in my Linux machine (running linux kernel 2.6.10). I would like to test the T1 interface but I don't have an ISDN PRI interface available right now. Is there a way to make some sort of loopback test? How to configure it? Do I need the cables to have tx/rx exchanged?

Any help would be appreciated.

- f

_______________________________________________
--Bandwidth and Colocation sponsored by Easynews.com --

Asterisk-Users mailing list
[email protected]
http://lists.digium.com/mailman/listinfo/asterisk-users
To UNSUBSCRIBE or update options visit:
   http://lists.digium.com/mailman/listinfo/asterisk-users

No virus found in this incoming message.
Checked by AVG Anti-Virus.
Version: 7.0.344 / Virus Database: 267.11.8/113 - Release Date: 9/27/05

>_______________________________________________
>--Bandwidth and Colocation sponsored by Easynews.com --
>
>Asterisk-Users mailing list
>[email protected]
>http://lists.digium.com/mailman/listinfo/asterisk-users
>To UNSUBSCRIBE or update options visit:
> http://lists.digium.com/mailman/listinfo/asterisk-users

_______________________________________________
--Bandwidth and Colocation sponsored by Easynews.com --

Asterisk-Users mailing list
[email protected]
http://lists.digium.com/mailman/listinfo/asterisk-users
To UNSUBSCRIBE or update options visit:
   http://lists.digium.com/mailman/listinfo/asterisk-users

No virus found in this incoming message.
Checked by AVG Anti-Virus.
Version: 7.0.344 / Virus Database: 267.11.8/113 - Release Date: 9/27/05

>_______________________________________________
>--Bandwidth and Colocation sponsored by Easynews.com --
>
>Asterisk-Users mailing list
>[email protected]
>http://lists.digium.com/mailman/listinfo/asterisk-users
>To UNSUBSCRIBE or update options visit:
> http://lists.digium.com/mailman/listinfo/asterisk-users

_______________________________________________
--Bandwidth and Colocation sponsored by Easynews.com --

Asterisk-Users mailing list
[email protected]
http://lists.digium.com/mailman/listinfo/asterisk-users
To UNSUBSCRIBE or update options visit:
   http://lists.digium.com/mailman/listinfo/asterisk-users

No virus found in this incoming message.
Checked by AVG Anti-Virus.
Version: 7.0.344 / Virus Database: 267.11.8/113 - Release Date: 9/27/05

>_______________________________________________
>--Bandwidth and Colocation sponsored by Easynews.com --
>
>Asterisk-Users mailing list
>[email protected]
>http://lists.digium.com/mailman/listinfo/asterisk-users
>To UNSUBSCRIBE or update options visit:
> http://lists.digium.com/mailman/listinfo/asterisk-users

_______________________________________________
--Bandwidth and Colocation sponsored by Easynews.com --


Asterisk-Users mailing list
[email protected]
http://lists.digium.com/mailman/listinfo/asterisk-users
To UNSUBSCRIBE or update options visit:
   http://lists.digium.com/mailman/listinfo/asterisk-users

Re: [Asterisk-Users] TE205P in loopback?

Reply via email to