Greg Oliver wrote:
Hmmmmm, I would have to disagree.
We use MGCP dial-peers and use it on PRIs with 3725s and 2851s
currently.
Our config was fubar'ed. We were using dial-peer "isdn" instead of
"pots". "direct-inward-dial" does not work with "isdn". We were
succussful with something like:
--
isdn switch-type primary-5ess
!
controller T1 3/0
framing esf
linecode b8zs
pri-group timeslots 1-24
description RCN PRI
!
interface Serial3/0:23
no ip address
isdn switch-type primary-5ess
isdn incoming-voice voice
no cdp enable
!
voice-port 3/0:23
!
dial-peer cor custom
!
dial-peer voice 4 voip
! We are matching the four digits that RCN is handing us going from
! 2100 to 2199. This needs to happen else the cisco will tend to route
! calls back out the PRI. :-)
destination-pattern 21..
session protocol sipv2
session target ipv4:1.2.3.4:5060
session transport udp
dtmf-relay rtp-nte
codec g711ulaw
no vad
!
dial-peer voice 200 pots
destination-pattern .T
direct-inward-dial
port 3/0:23
forward-digits all
!
sip-ua
retry invite 3
retry response 3
retry bye 3
retry cancel 3
timers trying 1000
sip-server ipv4:1.2.3.4
!
--
With this we have DIDs working.
Thanks to <[EMAIL PROTECTED]> for the sample configs.
Tim
_______________________________________________
--Bandwidth and Colocation sponsored by Easynews.com --
Asterisk-Users mailing list
[email protected]
http://lists.digium.com/mailman/listinfo/asterisk-users
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
