Glad to hear it! On Tue, 2005-10-04 at 17:53 -0700, Tim Pozar wrote: > Greg Oliver wrote: > > Hmmmmm, I would have to disagree. > > > > We use MGCP dial-peers and use it on PRIs with 3725s and 2851s > > currently. > > Our config was fubar'ed. We were using dial-peer "isdn" instead of > "pots". "direct-inward-dial" does not work with "isdn". We were > succussful with something like: > -- > isdn switch-type primary-5ess > ! > controller T1 3/0 > framing esf > linecode b8zs > pri-group timeslots 1-24 > description RCN PRI > ! > interface Serial3/0:23 > no ip address > isdn switch-type primary-5ess > isdn incoming-voice voice > no cdp enable > ! > voice-port 3/0:23 > ! > dial-peer cor custom > ! > dial-peer voice 4 voip > ! We are matching the four digits that RCN is handing us going from > ! 2100 to 2199. This needs to happen else the cisco will tend to route > ! calls back out the PRI. :-) > destination-pattern 21.. > session protocol sipv2 > session target ipv4:1.2.3.4:5060 > session transport udp > dtmf-relay rtp-nte > codec g711ulaw > no vad > ! > dial-peer voice 200 pots > destination-pattern .T > direct-inward-dial > port 3/0:23 > forward-digits all > ! > sip-ua > retry invite 3 > retry response 3 > retry bye 3 > retry cancel 3 > timers trying 1000 > sip-server ipv4:1.2.3.4 > ! > -- > With this we have DIDs working. > > Thanks to <[EMAIL PROTECTED]> for the sample configs. > > Tim > _______________________________________________ > --Bandwidth and Colocation sponsored by Easynews.com -- > > Asterisk-Users mailing list > [email protected] > http://lists.digium.com/mailman/listinfo/asterisk-users > To UNSUBSCRIBE or update options visit: > http://lists.digium.com/mailman/listinfo/asterisk-users
_______________________________________________ --Bandwidth and Colocation sponsored by Easynews.com -- Asterisk-Users mailing list [email protected] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
