I am running into issues with this same setup and would like to
update the wiki with information on connecting an avaya legend to an
asterisk server via a T100P. Please post your experiences with the
legend and asterisk so we can compile a great list of step by step
instructions for the wiki.
Some questions I have pertain to the protocol used between the MLPBX
and the T100P card.
We are running ML Release 7.0 with a 100D DS1 Card (hardware 1B,
firmware 90) and a Cross Over Cable (1,2,4,5 -> 4,5,1,2) to the T100P.
We have selected the Legend-Ntwk type on the ML side.
Should we be running something like 5ESS rather than legend-ntwk?
Again, if anyone has semi-detailed to detailed instructions for the
ML Legend or ML Magix please post them so we can update the wiki.
Sterling.
>Spectro,
>
>I have a T100P connected to my Merlin Magix and it works like a
champ. I am
>using an older T1 card (one pulled from a Merlin Legend) without any
>problems. The card is a "100D 1 T1 Trunk" blade.
>
>I have my system configured as a PRI (23B+D). The T100P is
configured to
>signal with pri_net and to provide timing. I used the 5ESS
protocol, but I
>suppose any of the PRI variants supported by both devices would work.
>
>I do not have (or need) any CSU/DSU equipment in between the two
devices. I
>simply built a crossover T1 cable (warning - not the same as an
Ethernet
>cross-over cable) and connected the two devices. The card and the
switch
>synched up and worked immediately.
>
>The hardest part was programming the ARS table to properly make use
of the
>connection.
>
>As for the insertion of the new card -- I had to do a "board
renumber" and
>it did mess with the dial plan on the switch a bit. Stations did not
>change, but the trunk numbering did. (This may be specific to my
>installation -- Magix/Legend are a field unto themselves.)
>
>Good luck with the install. My number is below if you have additional
>questions.
>
>Thanks,
>
>Steve
>
>Steven Sokol
>Owner/Manager
>Sokol & Associates, LLC
>
>Phone: 816.822.1807
>IaxTel: 700.613.9004
>Web: http://www.sokol-associates.com
>ASK ME ABOUT AstriCon 2004!
>http://www.astricon.net/
>
>
>> -----Original Message-----
>> From: asterisk-users-admin at lists.digium.com [mailto:asterisk-
users-
>> admin at lists.digium.com] On Behalf Of spectro
>> Sent: Sunday, August 22, 2004 11:25 AM
>> To: asterisk-users at lists.digium.com
>> Subject: [Asterisk-Users] asterisk T100P to Merlin Legend
>>
>> Management just approved purchase of a Digium T100P and a T1 card
for
>> our Merlin Legend Switch. I will appreciate comments from anyone
>> performing this installation before:
>>
>> - Which T1 card did you use in the Merlin Legend?
>> - Did you require any special interface? (CSU/DSU, etc)
>> - Any items to watch during installation.
>>
>> Also we will need to remove one of our old analog Trunk cards to
>> accomodate the new T1 interface in the switch. This switch
already has
>> two T1 cards in it. I don't know much about restriction in the
Merlin
>> Legend Switch, but our phone tech told me some horror stories about
>> taking a card out of the switch. I know this is OT and we will
>> probably have our switch part supplier to take care of that but I
will
>> appreciate any comments.
>>
>> Thanks in advance
>> _______________________________________________
>> Asterisk-Users mailing list
>> Asterisk-Users at lists.digium.com
>> http://lists.digium.com/mailman/listinfo/asterisk-users
>> To UNSUBSCRIBE or update options visit:
>> http://lists.digium.com/mailman/listinfo/asterisk-users
_______________________________________________
--Bandwidth and Colocation sponsored by Easynews.com --
Asterisk-Users mailing list
[email protected]
http://lists.digium.com/mailman/listinfo/asterisk-users
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
