Same problem here but cat /proc/pci showed me a different IO address then the standard one so i replaced it in the make file and off i went :)
greetings, Tjardick ----- Original Message ----- From: "Stuart Mackintosh" <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Sent: Monday, October 13, 2003 1:25 PM Subject: Re: [Asterisk-Users] "New" TDM cards--driver won't load > Hi all, FYI, > > I had a similar problem where the new TDM card would show up in > /proc/pci but would not load the module. > > Checked out the latest CVS zaptel, made / installed and loaded straight > away. Used Gigabyte GA-8S648 board. > > Stuart. > > > On Fri, 2003-10-03 at 19:49, Mark Spencer wrote: > > > > Is it showing up on /proc/pci? It should be a tigerjet. > > > > > > Yes. I put the other card back in (production machine) but over the > > > weekend I'll get the card in there and capture the output of lspci. > > > > If the card shows up in /proc/pci then your motherboard *must* be > > supplying 3.3V somehow (unless it's just leaking back somehow, but that > > doesn't seem very likely). > > > > > Nope. Doesn't show any sign of seeing the card at all. It does see the > > > FXO card that's in the same machine. > > > > We should check the PCI ID's. There may be a difference in what we're > > looking for and what is there. > > > > Mark > > > > _______________________________________________ > > Asterisk-Users mailing list > > [EMAIL PROTECTED] > > http://lists.digium.com/mailman/listinfo/asterisk-users > -- > > | http://www.opusvl.com > | T: 08717 50 40 02 > | F: 08717 50 40 03 > | E: [EMAIL PROTECTED] > > _______________________________________________ > Asterisk-Users mailing list > [EMAIL PROTECTED] > http://lists.digium.com/mailman/listinfo/asterisk-users > _______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users
