Which version of divas driver do you use? If it's the v2 driver (from melware.de or in-kernel 2.6), then you need to set echocancelold=yes
in the interfaces sections. If you use the new driver v3 (Eicon source RPM), echocancelold=yes may not be set. Armin On Mon, 3 Apr 2006, Giuseppe wrote: > Thanks Avi Miller! > > Here it is my capi.conf file > > [general] > nationalprefix=039 > ;;internationalprefix=011 > rxgain=1.0 > txgain=2.0 > alaw=yes ; > > [ISDN3] ;this example interface gets name 'ISDN1' and may be any > ntmode=yes ;if isdn card operates in nt mode, set this to yes when > using NT-mode, ptp should be set in any case > incomingmsn=* ;allow incoming calls to this list of MSNs/DIDs, * > == any > controller=3 ;capi controller number to use > group=1 ;dialout group > ;softdtmf=on ;enable/disable software dtmf detection, recommended > for AVM cards > ;relaxdtmf=on ;in addition to softdtmf, you can use relaxed dtmf > detection > ;accountcode= ;Asterisk accountcode to use in CDRs > context=isdn3in ;context for incoming calls > holdtype=local ;If set to 'hold', when Asterisk puts the call on > hold, ISDN HOLD will be used. > immediate=yes ;immediate start of pbx with extension 's' if no > digits were received on incoming call (no destination number yet) > ;echosquelch=1 ;_VERY_PRIMITIVE_ echo suppression > echocancel=yes ;EICON DIVA SERVER (CAPI) echo cancelation > (possible values: 'no', 'yes', 'force', 'g164', 'g165') > ;echocancelold=yes ;use facility selector 6 instead of correct 8 > (necessary for older eicon drivers) > echotail=64 ;echo cancel tail setting > bridge=yes ;native bridging (CAPI line interconnect) if available > callgroup=1 ;Asterisk call group > ;deflect=1234567 ;deflect incoming calls to 1234567 if all B channels > are busy > devices=2 ;number of concurrent calls on this controller (2 makes > sense for single BRI, 30 for PRI) > > Is there something wrong? > > Thanks again! > > Giuseppe > > Avi Miller ha scritto: > > > Giuseppe wrote: > > > > > I'm always getting this error when echo cancellation should start. > > > > > > What does your /etc/asterisk/capi.conf look like? > > > > Also, have you configured your Eicon correctly? You may need to enable > > the Eicon web interface and check that each port is correct. > > > > _______________________________________________ > --Bandwidth and Colocation provided by Easynews.com -- > > Asterisk-Users mailing list > To UNSUBSCRIBE or update options visit: > http://lists.digium.com/mailman/listinfo/asterisk-users > _______________________________________________ --Bandwidth and Colocation provided by Easynews.com -- Asterisk-Users mailing list To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
