Jerry and Michael, many many thanks for your posts. Erick.
On 5/24/06, The VoIP Connection <[EMAIL PROTECTED]> wrote:
Here are the step by step instructions for setting up a brand new Audiocodes FXS gateway for use with an Asterisk server: Connect the gateway to a network switch and connect a computer to the same switch. Then configure the IP address of the computer to 10.1.10.2. Then run your web browser and point it to http://10.1.10.10 and login using the information below. Default IP address: 10.1.10.10 Default user name: Admin Default password: Admin Goto "Quick Setup" and change the following: IP Address => Set to the new IP address of the AudioCodes gateway Subnet Mask => Set to the correct netmask for your local network Default Gateway Address => Set to the correct gateway IP address for your local network Working With Proxy => Set to "Yes" Proxy IP Address => Set to the IP address of the Asterisk server Enable Registration => Set to "Enable" Restart the gateway then log back in using the new IP address. Goto Protocol Management -> Protocol Definition -> Proxy & Registration Registrar IP Address => Set to the IP address of the Asterisk server Registration Time => Set to "60" Subscription Mode => Set to "Per Endpoint" Authentication Mode => Set to "Per Endpoint" Goto Protocol Management -> Protocol Definition -> DTMF & Dialing Max Digits In Phone Num => Set to a large enough number such as "32" Goto Protocol Management -> Protocol Definition -> Coders Add coders as needed You need to set at least G.711U-law Goto Protocol Management -> Endpoint Settings -> Authentication Set SIP username and password for each port Goto Protocol Management -> Endpoint Phone Numbers Enter an extension (phone) number for every used channel Your AudioCodes gateway is now ready. Michael Crown Managing Partner www.thevoipconnection.com 321.989.6728 ext. 611 sip:[EMAIL PROTECTED] > -----Original Message----- > From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] > Sent: Wednesday, May 24, 2006 10:23 PM > To: [EMAIL PROTECTED] > Subject: RE: [Asterisk-Users] OT: AudioCodes MP124-C/FSX/AC/SIP > > FXS > > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] On Behalf Of > The VoIP Connection > Sent: Wednesday, May 24, 2006 9:25 PM > To: 'Asterisk Users Mailing List - Non-Commercial Discussion' > Subject: RE: [Asterisk-Users] OT: AudioCodes MP124-C/FSX/AC/SIP > > FXS or FXO? > > Michael Crown > Managing Partner > www.thevoipconnection.com > 321.989.6728 ext. 611 > sip:[EMAIL PROTECTED] > > > > -----Original Message----- > > From: William Piper [mailto:[EMAIL PROTECTED] > > Sent: Wednesday, May 24, 2006 6:27 PM > > To: 'Asterisk Users Mailing List - Non-Commercial Discussion' > > Subject: RE: [Asterisk-Users] OT: AudioCodes MP124-C/FSX/AC/SIP > > > > Sorry to hijack your thread. > > > > Reading these posts made me grab my old MP-104 & try again > to get it > > working with asterisk. I bought it a while ago off eBay & > never could > > get it to register. > > > > Does anyone have an example ini file for the MP-1XX that I > could look > > at & figure out what I am configuring wrong on this box? > > > > Thanks, > > > > bp > > > > -----Original Message----- > > From: [EMAIL PROTECTED] > > [mailto:[EMAIL PROTECTED] On Behalf Of Jerry > > Jones > > Sent: Wednesday, May 24, 2006 6:04 PM > > To: Asterisk Users Mailing List - Non-Commercial Discussion > > Subject: Re: [Asterisk-Users] OT: AudioCodes MP124-C/FSX/AC/SIP > > > > From my copy of the manual > > > > > > MP-1xx SIP User's Manual 36 Document #: LTRT-65404 You can use the > > 'Reset' button to restore the MP-1xx networking parameters to their > > factory default values (described in Table 4-1) and to reset the > > username and password. > > Note that the MP-1xx returns to the software version burned > in flash. > > This process also restores > > the MP-1xx parameters to their factory settings, therefore you must > > load your previously backed- up ini file, or the default ini file > > (received with the software kit) to set them to their > correct values. > > To restore networking parameters to their initial state, > take these 6 > > steps: > > 1. Disconnect the MP-1xx from the power and network cables. > > MP-1xx SIP User's Manual 4. Getting Started 2. Reconnect the power > > cable; the gateway is powered up. After approximately > > 45 seconds the Ready LED turns to green and the Control LED > blinks for > > about 3 seconds. > > 3. While the Control LED is blinking, press shortly on the reset > > button (located on the left side of the front panel); the gateway > > resets a second time and is restored with factory default > parameters > > (username: "Admin", password: "Admin"). > > 4. Reconnect the network cable. > > 5. Assigning the MP-1xx IP address (refer to Section 4.1 > on page 35). > > 6. Load your previously backed-up ini file, or the default ini file > > (received with the software kit). > > To load the ini file via the Embedded Web Server, refer to > Section > > 5.9.2.1 on page 120. > > > > > > > > > > On May 24, 2006, at 3:00 PM, Erick Perez wrote: > > > > > Just a question, has anyone knows how to blank or factory > reset an > > > AudioCodes MP124-C/FSX/AC/SIP unit (it's a 24 FSX to SIP unit). > > > I purchased them second-handed with no manuals (thank god for the > > > internet!!) but i guess the pdf manual I have does not have the > > > section of factory-reset. > > > > > > Also, any sucess stories with: > > > AudioCodes MP124-C/FSX/AC/SIP > > <--->Asterisk<---internet<--->Vonage > > > setups? > > > > > > Thanks, > > > > > > > > > -- > > > > > > ------------------------------------------- > > > Erick Perez > > > Linux User 376588 > > > http://counter.li.org/ (Get counted!!!) Panama, Republic > of Panama > > > _______________________________________________ > > > > > > > > > > _______________________________________________ > --Bandwidth and Colocation provided by Easynews.com -- > > Asterisk-Users mailing list > To UNSUBSCRIBE or update options visit: > http://lists.digium.com/mailman/listinfo/asterisk-users > > > __________ NOD32 1.1556 (20060525) Information __________ > > This message was checked by NOD32 antivirus system. > http://www.eset.com > > _______________________________________________ --Bandwidth and Colocation provided by Easynews.com -- asterisk-biz mailing list To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-biz
-- ------------------------------------------- Erick Perez Linux User 376588 http://counter.li.org/ (Get counted!!!) Panama, Republic of Panama _______________________________________________ --Bandwidth and Colocation provided by Easynews.com -- Asterisk-Users mailing list To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
