Zapata Telephony Interface Registered on major 196 Zaptel Version: 1.2.5 Echo Canceller: MG2 Failed to initailize DAA, giving up... wcfxo: probe of 0000:00:0e.0 failed with error -5
these lines means, your x100p is not initialized - therefore cannot be used by zaptel. the problem below, reported by ztconfig. as the usage of zaptel device is following: modprobe zaptel modprobe module_of_card (like wcfxo) if it found, ztcfg if you see the device in /proc/zaptel/1 (or 2 or so) you can start asterisk and enjoy the device. you can believe me, this problem is in relation with irq sharing. (as i meet with that problem every time i have installed more than one card in a box - what i did more than 20 times) > Hello. > "ZT_CHANCONFIG failed on channel 1: No such device or address (6)" > I think that this error, is saying that its X100P is not connected in slot > PCI correctly. He makes a test, he changes the X100P of slot and he sends > for the list the commands lspci, dmesg, cat /proc/interrupts. I wait to > have helped. > Best Regards > Josué > > 2006/6/3, Woodoo People .pGa! <[EMAIL PROTECTED]>: > > > >> So I took a chance with an X100P knock-off on eBay. I'm running Asterisk > >+ > >> FreePBX on a PowerMac G3 (beige desktop) using Slackintosh 10.2 and > >kernel > >> 2.6.16.16. Everything has been fine up until now. > >> I compile the 1.2.5 Zaptel drivers without a problem, get the udev > >> configuration in, modprobe zaptel, and finally modprobe wcfxo. At this > >> point, I get the message: > >> > >> ZT_CHANCONFIG failed on channel 1: No such device or address (6) > >> FATAL: Error running install command for wcfxo > >> > >> dmesg gives me: > >> > >> Zapata Telephony Interface Registered on major 196 > >> Zaptel Version: 1.2.5 Echo Canceller: MG2 > >> Failed to initailize DAA, giving up... > >> wcfxo: probe of 0000:00:0e.0 failed with error -5 > > > >this is a problem if the card shares interrupt with something on > >MOtherBOard. > >configure the slot to other irq, or move the card to other irq. > >lspci -v will be your friend. Check if someone uses same IRQ as motorola > >card. > > > > > >-- > >WoodOO-[P]an[G]alaktikan[A]gent-People <][> http://shadow.pganet.com > >[EMAIL PROTECTED]@ > >RedHat.users > >_______________________________________________ > >--Bandwidth and Colocation provided by Easynews.com -- > > > >Asterisk-Users mailing list > >To UNSUBSCRIBE or update options visit: > > http://lists.digium.com/mailman/listinfo/asterisk-users > > > _______________________________________________ > --Bandwidth and Colocation provided by Easynews.com -- > > Asterisk-Users mailing list > To UNSUBSCRIBE or update options visit: > http://lists.digium.com/mailman/listinfo/asterisk-users -- WoodOO-[P]an[G]alaktikan[A]gent-People <][> http://shadow.pganet.com [EMAIL PROTECTED]@RedHat.users _______________________________________________ --Bandwidth and Colocation provided by Easynews.com -- Asterisk-Users mailing list To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
