> -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] On Behalf Of > Thomas Kenyon > Sent: Monday, June 12, 2006 2:06 PM > To: Asterisk Users Mailing List - Non-Commercial Discussion > Subject: Re: [Asterisk-Users] use AT320 international call > > > Min Qiu wrote: > > Hi all, > > > > The firmware I used is pa168s_iax2_us_151011.bin. > > > > My problem is the handset dial before I finished key in all > > the numbers, no matter how fast I managed to press the keys. > > It appeared it always dialed immediately, for example "011862", > > when I actually ment to dial 0118620xxxxxxxx. Thus left the > > remaining numbers "0xxxxxxxx" unsent. > > > > The handset had its dial plan disabled. It configured to use > > iax protocol. My extensions.conf has this: > > > > exten=_01186.,1, dial(SIP/<voipprovider>,60) > > > > and it works fine with other iaxy and Cisco ATA. > > > > Anyone encounter this symptom? Can you share your experience? > > > > Thanks, > > > > Min > > > > > Do you have remote dialplan ticked? (only available in the > IAX firmware).
Not sure, I'll double check... > This function causes the above effect and can only appears to > work with > very simple dialplans and should generally not be used. > > You may want to roll-back to the 1.50 firmware (ask if you > can't find it > elsewhere) there are sound quality issues with the 1.51 release. Arh... I did experence sound quality issues and I pointed my finger toward my VoIP provider;-) Good to know. Can you pass a pointer to where I can get 1.50? Thanks a lot, Min > > > _______________________________________________ > --Bandwidth and Colocation provided by Easynews.com -- > > Asterisk-Users mailing list > To UNSUBSCRIBE or update options visit: > http://lists.digium.com/mailman/listinfo/asterisk-users > _______________________________________________ --Bandwidth and Colocation provided by Easynews.com -- Asterisk-Users mailing list To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
