Should be span 1 for the for T1 and span 2 for the second T1 in your config. They are both span 1.
-----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Jerry Geis Sent: Thursday, July 13, 2006 12:47 PM To: [email protected] Subject: [asterisk-users] quad T1 pri I am connecting my Quad T1 card to the Siemens HIpath 4000 with pri. Port 1 is working just fine. But port 2 is not working. I think I have my configuration correct (see below). Is there something special about configuring 2 PRI? I have done it with dual T1 no problem. I am using asterisk 1.2.9.1 libpri-1.2.3 and zaptel 1.2.6. THanks, Jerry ------------------ zaptel.conf: span=1,1,0,esf,b8zs bchan=1-23 dchan=24 span=1,1,0,esf,b8zs bchan=25-47 dchan=48 zapata.conf: signalling=pri_cpe switchtype=national echocancel=yes echocancelwhenbridged=yes echotraining=400 callerid=asreceived context=smvoice-incoming group=1 channel => 1-23 signalling=pri_cpe switchtype=national echocancel=yes echocancelwhenbridged=yes echotraining=400 callerid=asreceived context=smvoice-incoming group=1 channel => 25-47 _______________________________________________ --Bandwidth and Colocation provided by Easynews.com -- asterisk-users mailing list To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users _______________________________________________ --Bandwidth and Colocation provided by Easynews.com -- asterisk-users mailing list To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
