Hi In dial-peer voice 697617664 voip your must specify into voip dial peer
session protocol sipv2 and check if session target sip-server is corect doing a ping to sip-server . I think you must configure it with ipv4:ip_addres or map a host entry with ip host sip-server x.x.x.x in global configuration mode you have forgotten to configure a pots dial peer for your controler. put something like this dial-peer voice 10 pots destination-pattern 0T fax rate disable direct-inward-dial port 1/0:15 and try if you can write authentication username "asterisk-uername" password XXXXXX this last command should allow dial-peer voice 10 to register within asterisk I hope it will help you best regards 2006/12/7, FaberK <[EMAIL PROTECTED]>:
Hi to all, I got a Cisco 2651XM wired to an E1 PRI. What I want to do is to pass all incoming calls to my asterisk. This is my actual conf: http://pastebin.ca/270677 with this I'm able to call my number from outside, but the call stop on the 2600, infact I can hear the tone, but I'm not able to forward calls to my asterisk. Anyone got an idea of my errors? Thanks to all. -- .:FaberK:. _______________________________________________ --Bandwidth and Colocation provided by Easynews.com <http://easynews.com/>-- asterisk-users mailing list To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
_______________________________________________ --Bandwidth and Colocation provided by Easynews.com -- asterisk-users mailing list To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
