On Fri, Apr 06, 2007 at 01:18:24AM +0200, Henrik Woffinden wrote:
> Hello list,
>
> After upgrading from BRIstuff 1y-b to 1y-e my ISDN card is suddently
> detected as 2 ports instead of 4.
>
> I still load the driver as "modprobe qozap ports=12" as I've always
> done. But now it only sees 2 ports.
> Output of "lspci -vvv"
> ------ cut --------
> 02:01.0 ISDN controller: Cologne Chip Designs GmbH ISDN network
> Controller [HFC-4S] (rev 01)
> Subsystem: Cologne Chip Designs GmbH Unknown device b560
> Control: I/O+ Mem+ BusMaster- SpecCycle- MemWINV- VGASnoop-
> ParErr- Stepping- SERR- FastB2B-
> Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort-
> <TAbort- <MAbort- >SERR- <PERR-
> Interrupt: pin A routed to IRQ 22
> Region 0: I/O ports at ddb8 [size=8]
> Region 1: Memory at fcefa000 (32-bit, non-prefetchable) [size=4K]
> Capabilities: [40] Power Management version 2
> Flags: PMEClk- DSI+ D1+ D2+ AuxCurrent=0mA
> PME(D0+,D1+,D2+,D3hot+,D3cold-)
> Status: D0 PME-Enable- DSel=0 DScale=0 PME-
> ------ cut --------
Just a comment: the CHANGES file has the item "fixed detection of
miniPCI cards (qozap)". Take a look at the diff between qozap/qozap.c
in -d and in -e .
--
Tzafrir Cohen
icq#16849755 jabber:[EMAIL PROTECTED]
+972-50-7952406 mailto:[EMAIL PROTECTED]
http://www.xorcom.com iax:[EMAIL PROTECTED]/tzafrir
_______________________________________________
--Bandwidth and Colocation provided by Easynews.com --
asterisk-users mailing list
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
