If you are VoIP-only then you need a SIP provider that offers T.38. On Wed, Oct 22, 2008 at 11:17 PM, Brendan Martens <[EMAIL PROTECTED]> wrote: > I am using 1.6.0.1 and we are going to be pure voip. I know it has > pass through and termination, but that is useless if I don't have a > way to transform the analog t.30 to t.38 before it gets to me. That is > where my confusion lays, is there some way of doing this that I am not > aware of? > > Brendan Martens > > On Oct 22, 2008, at 3:02 PM, Jonn R Taylor wrote: > >> What version of *? Are you going all VOIP for your voice or are you >> using a T1/E1? *? >> >> 1.4 has t38 pass-through and 1.6 has pass-through and termination, >> but 1.6 was just release and I would not suggest using it in a >> production environment unless you can tolerate problem or even >> outages. >> >> If you are planning on using a T1/E1 then send incoming calls to >> iaxmodem/hylafax or to an ATA/FXS card. Either works very well. >> >> Jonn >> >> -----Original Message----- >> From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] >> ] On Behalf Of Brendan Martens >> Sent: Wednesday, October 22, 2008 12:25 PM >> To: Asterisk Users Mailing List - Non-Commercial Discussion >> Subject: [asterisk-users] fax / t38 gateway >> >> I'm trying to figure out how to handle our fax line when we switch to >> our asterisk for voice. After a lot of reading and poking about I have >> concluded, as have many others it would seem, that the best thing to >> do is either to have a separate pstn fax line or use some sort of >> internet faxing service rather than try and make faxing work in a way >> it's not meant to over voip lines. >> >> The question I can't seem to find a good answer to is if there is a >> service/software that would allow a DID to be transferred to them and >> then they perform the t.38 gateway/conversion functions to which I can >> connect with asterisk as a t.38 endpoint and originator, or if there >> is a way that I could host that on my own server? >> >> So essentially I am a bit confused that asterisk supports t.38 as an >> endpoint or originator, but there doesn't seem to be a way to convert >> to/from analog for interoperating with "normal" fax machines. I'm sure >> something exists or the code wouldn't have been written into >> asterisk... Can someone point me in the right direction? >> >> >> Brendan Martens >> >> _______________________________________________ >> -- Bandwidth and Colocation Provided by http://www.api-digital.com -- >> >> asterisk-users mailing list >> To UNSUBSCRIBE or update options visit: >> http://lists.digium.com/mailman/listinfo/asterisk-users >> >> >> >> >> _______________________________________________ >> -- Bandwidth and Colocation Provided by http://www.api-digital.com -- >> >> asterisk-users mailing list >> To UNSUBSCRIBE or update options visit: >> http://lists.digium.com/mailman/listinfo/asterisk-users > > > _______________________________________________ > -- Bandwidth and Colocation Provided by http://www.api-digital.com -- > > asterisk-users mailing list > To UNSUBSCRIBE or update options visit: > http://lists.digium.com/mailman/listinfo/asterisk-users >
_______________________________________________ -- Bandwidth and Colocation Provided by http://www.api-digital.com -- asterisk-users mailing list To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users