I am trying to connect * E100P directly to Cisco using an ATM circuit. The ATM circuit is ok (I can connect to Ciscos). I do not understando too much about Cisco syntax, please help me.
############# Cisco Conf:
isdn switch-type primary-net5 isdn voice-call-failure 0
controller E1 3 framing NO-CRC4 clock source line primary pri-group timeslots 1-31
interface Serial3:15 no ip address isdn switch-type primary-net5 isdn overlap-receiving T302 2000 isdn incoming-voice modem isdn send-alerting no cdp enable
############# Zaptel.Conf:
span=2,1,0,ccs,hdb3,yellow bchan=32-46,48-62 dchan=47
############# Zapata.conf:
callwaiting=yes callwaitingcallerid=yes threewaycalling=no transfer=no cancallforward=no callreturn=no echocancel=yes echocancelwhenbridged=yes group = 2 signalling = pri_net switchtype = national channel => 32-46 channel => 48-62
Thanks in advance,
Daniel
_______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users
