You are trying to have both ends act as users, cisco can support emulating a network interface (isdn protocol-emulate in serial interface config) but in my experience i could get the circuit up but it would bounce and i couldnt get signalling to work.. to be fair my IOS is quite old and wouldnt support the switch types that I think I needed
Steve On Wed, 7 Jan 2004, Daniel Bichara wrote: > Hi, > > I am trying to connect * E100P directly to Cisco using an ATM circuit. > The ATM circuit is ok (I can connect to Ciscos). I do not understando > too much about Cisco syntax, please help me. > > ############# > Cisco Conf: > > isdn switch-type primary-net5 > isdn voice-call-failure 0 > > controller E1 3 > framing NO-CRC4 > clock source line primary > pri-group timeslots 1-31 > > interface Serial3:15 > no ip address > isdn switch-type primary-net5 > isdn overlap-receiving T302 2000 > isdn incoming-voice modem > isdn send-alerting > no cdp enable > > ############# > Zaptel.Conf: > > span=2,1,0,ccs,hdb3,yellow > bchan=32-46,48-62 > dchan=47 > > ############# > Zapata.conf: > > callwaiting=yes > callwaitingcallerid=yes > threewaycalling=no > transfer=no > cancallforward=no > callreturn=no > echocancel=yes > echocancelwhenbridged=yes > group = 2 > signalling = pri_net > switchtype = national > channel => 32-46 > channel => 48-62 > > Thanks in advance, > > Daniel > > > _______________________________________________ > Asterisk-Users mailing list > [EMAIL PROTECTED] > http://lists.digium.com/mailman/listinfo/asterisk-users > _______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users
